Menu
Van Marcke Dritto 60 Quick Start Manual
    |
(Fig. 1)2 & Outside ZoneAll installations must comply with guidelines which are based on a zonalconcept. The diagram above illustrates this concept and must be followed toensure the safe installation of electrical appliances in the bathroom. Theseregulations apply to domestic installations only. Installations must be madein accordance with the current IEE wiring regulations and relevant buildingregulations. We recommend that all electrical bathroom products should onlybe fitted by a suitably qualified, Part P registered electrician.Thank you for purchasing this product.Please read through these instructions carefully and refer back to themduring installation to ensure that your product is fitted safely and that itretains its high quality finish.Please retain this leaflet for future reference.Before installation, ensure the domestic electrical mains supply to whichthe mirror is to be connected is turned off. Before drilling, ensure thatthere are no hidden cables or pipes in the wall.Mounting Points Diagram (Fig. A)Illuminated MirrorsDritto 60 Art No. 221110 / Dritto 80 Art No. 221111Dritto 100 Art No. 221112Installation1. Position the mirror in a suitable location (according to thezonal diagram - Fig. 1), ensuring that the domestic electricalmains supply is within reach of the electrical entry point of theproduct.2. Carefully mark the position of the mirror using a soft pencilensuring it is level. Remove the mirror and mark the mountingpoints. Please ensure that all marked mounting pointsaccurately match up with the fixing points on the mirror.3. Using a suitable drill bit, drill holes in the marked positions to asuitable depth. If drilling through tile, use a ceramic drill bit.4. Insert wall plugs level with the surface of the wall. If fittingto a tiled surface, wall plugs should be inserted below thetile surface to avoid cracking. NB. For plasterboard walls,specialist fixings should be purchased, available from any DIYor hardware store.5. Screw supplied fixings into wall plugs.6. Ensure the domestic electrical mains supply to which themirror is being connected is turned off. Connect the domesticmains supply to the terminal box according to the wiringdiagram (Fig. B).7. Hang the mirror in position.8. Switch the domestic electrical mains supply for the mirror backon.mounting pointsREAR VIEWOperation InstructionsTo turn illumination on or off, press the touch sensor.To cycle through warm to cool colour temperature, press and hold thetouch sensor - release when the desired colour temperature has beenreached.Heated Pad is only on when mirror is illuminated.Care InstructionsDo not use abrasives or solvents when cleaning this product. Wipe off allwater spillages as soon as possible using a soft, damp cloth.Aftercare ServiceIn the unlikely event that this product should fail please contact ourcustomer services.WEEE complianceMust not be mixed with general household wasteliveear thneutralMAINS SUPPLYLUMINAIRELi ve supply can be R ed or BrownNeut ral supply can be Blue or BlackEarth supply is Green and Yell owLi ve is BrownNeut ral is BlueWiring Diagram (Fig. B)CautionWe recommend that you place this mirror on a soft flat surface to ensure no breakages.We also recommend that you leave corner protectors on until final fitting.This product is suitable for installation in zones:EN |
Related manuals for Van Marcke 221110
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved