Valet System One Installation Instructions Manual

Also see for System One: User manual Owner's manual

Valet System One Installation Instructions Manual Manual pdf 34 page image

33SIX WIRE OPERATION USING VR102 ROOM STATIONSAlthough System One is designed to operate optimally using 8 wire Hook-up, it willalso operate using 6 wire hook-up with the trade off that music will mute at all stationsduring private communication. (With 8 wire hook-up music only mutes at the 2 stationsinvolved in communication)To operate a system using 6 wire hook-up, the following is required.Master Station (Special Order Only)Jumpers are to be inserted on jumper pins L1 & L4 on main board of master.Orange terminal must be linked to blue terminal at master.Green terminal must be linked to white terminal at master.Music lines (Green & Orange) are omitted.Room StationsPress “PRIVACY” and “MONITOR” buttons simultaneously to enter Program Mode.Press “HOUSE” button to select “6 wire” mode. (Green LED off)Press “CLEAR” button to exit Program Mode.Music lines (MUS1 and MUS2) are omitted. (No wire links required at Room Stations)The station will toggle between 6 wire mode (Green LED off) and 8 wire mode (Green LED on)each time the “HOUSE” button is pressed while in program mode.REDBLACKSHIELDED REDSHIELDED WHITEBLUEWHITEGREENORANGEPOSNEGTCVLCCOM1COM2MASTERROOM DOOR(VR102)NOTE: If using Auxiliary Input Jack Type B, connect green& orange terminals of input jack to COM1 & COM2terminals at Room Station.Be sure to bridge 6 Wire Jumper (L1) on Input Jack

/ 35

Related manuals for Valet System One