Valcom V-A2412 Installation Manual

Also see for V-A2412: Installation manual

Contents

Valcom V-A2412 Installation Manual Manual pdf 7 page image

7Valcom, Inc.5614 Hollins RoadRoanoke, VA 24019540-563-2000 P.540-362-9800 F.www.valcom.comt Plug and secure wiring to clock - Loosen and slip excess wiring through provided wire clamp (comes attached to each clock adaptor) andtighten the clamp. After securing excess wiring, plug the jack at the end of the wiring into the appropriate jack on the back of the clock. Ifusing IP clocks, wiring will not be supplied with the clocks - the installer will be responsible for supplying all Ethernet wiring.y Attach and screw clocks to adaptors - Find all four (4) tabs located on each adaptor. Snap the clock onto the adaptor, making sure allfour (4) tabs on the adaptor are secured to the clock (if installing battery powered clocks, make sure batteries are installed at this point).After securing the clock to the adaptor with the tabs, the clock should be able to rotate 5 degrees left and right. Rotate to align the clockswith the ceiling or wall. Secure its position by using the four (4) 6-19 x 7/16” screws that come attached to the clock adaptor from the factoryand screw them into the four (4) tabs on the adaptor.Plastic Double Mount Installation