Valcom V-2001A User Manual

Also see for V-2001A: Design/information Quick start guide Technical specifications Brochure

Contents

Valcom V-2001A User Manual Manual pdf 2 page image

2• Supplies 20 Valcom power units forpowering Valcom one-way amplifiedspeakers (1 Amp -24VDC); Additional powersupplies are required for a quantity ofspeakers using over 20 power units• Page with music outputs (2 provided); musicmutes during page• Page without music output• Battery backup input (Use Valcom VPB-260battery backup supply)• Time clock/single tone (Contact closureactivated)• Night ring/warble tone (Closure or 90VACactivated)Priority sequence of tones:Page overrides musicNight ring mixes with music and pageTime clock mixes with music and page• Individual switches for selection of night ringand time clock tones per output• May be used with 25 or 70 Volt amplifiers• AC powered, 115 or 230VAC• Internationally recognized power connector• AC input fused at 1 Amp @ 115VAC, 60Hzor 0.5 Amp @ 230VAC, 50Hz• 115/230 Volt selector switch for internationaluse• UL listedDimensions/Weight• 7.06"H x 9.00"W x 2.40"D(17.93cm H x 22.86cm W x 6.10cm D)• Weight: 3.7 lbs. (1.68 kg)Nominal SpecificationsInput Impedance: 600 OhmsInput Level: -10dBm nominalVoice Switch Sensitivity: -21dBmMusic Source Input Impedance: 8 to 600 OhmsMusic Input Level: -10dBm nominalOutput Impedance: 8 OhmsOutput Level: -10dBm nominalDC Output: 1 Amp at -24VDCNominal Power RequirementsVoltage: Current:115VAC 1.0 Amp230VAC 0.5 AmpBattery BackupThe V-2001A is equipped with a standard3-prong polarized MOLEX connector to allowconnection of a fused output (3 Amp) batterybackup supply (Valcom VPB-260 or equivalent)in case of AC power failure. Backup time will bea function of system usage.• Use a cord set consisting of a minimum 18AWG cord and grounding type attachmentplug rated a minimum of 15A, 250V. Thecord set should have the appropriate safetyapprovals for the country in which theequipment will be installed and should bemarked HAR.• The socket outlet shall be installed near theequipment and shall be easily accessible.NOTE: The AC line cord of the VPB-260 andthe AC line cord of the V-2001A should beplugged into the same AC circuit.EnvironmentTemperature: 0 to +40° CHumidity: 0 to 85% non-precipitatingINSTALLATIONNOTE: The telephone system referred to inthis manual is the customer premiseequipment such as an electronic key system,a PABX or a dedicated single linetelephone(s). The V-2001A is not intendedfor direct or indirect connection to the publictelephone network or to PABX analog stationports. When used with a customer premisetelephone system such as a key systemor PABX system, these units are interfacedto the system via a fully protected page portor system central office port, which is a fullyprotected interface device. Also, the hostsystem must be configured to disallowcentral office trunk conferencing in order toprevent indirect connection to the publicnetwork.Precautionary DesignationsCAUTION: To reduce the risk of electric shock,Do not remove cover.No user serviceable parts inside.Refer servicing to qualified service personnel.This symbol indicates that dangerousvoltage constituting a risk of electricshock is present within this unit.This symbol indicates that there areimportant operating and maintenanceinstructions in the literature accompanyingthis unit.CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPEN