VSP-V-1094AIssue 7V-1094APAGE PORT PREAMP/EXPANDERINTRODUCTIONThese instructions contain the specifications andinformation necessary to install, operate and maintainthe V-1094A Page Port Preamp/Expander.SPECIFICATIONSDesignThe Valcom V-1094A Page Port Preamp/ Expander isa solid-state audio preamplifier. The unit comes withits own surface mount box, which provides ½ inchconduit access. The amplifier will accept a highimpedance input (600 Ohms) and reduce it to a lowimpedance output. When the control knob is set on 5,the input signal level equals the output signal level.Frequency Response: 80Hz to 10kHz +/-3dBGain (into 8 Ohm load): +8dB maximumThe V-1094A is capable of driving 150 Valcomone-way speaker/amplifier assemblies.INSTALLATIONApplications These instructions cover only the installation of theValcom V-1094A. Consult the practices of otherequipment if any other equipment is used.• To interface 600 Ohm type page ports to up to150 Valcom amplified speakers• To expand the number of Valcom amplifiedspeakers on a zone by 150InputV-1094APage PortPreampExpander600 Ohm page portor zone output of apage control unitPower SupplyUp to 150One-WayAmplifiedSpeakersT R(J1)(J3)OutputTR(J2)-24V GND Input level equals outputlevel at position 5Audio and Power Connections• To pre-amp audio signal on long lines to Valcomamplified speakers• To provide master volume control convenienceto all or a portion of a paging zoneDimensions/Weight• 4.44"H x 2.75"W x 2.88"D(11.28cm H x 6.99cm W x 7.32cm D)• 0.9 lbs. (0.41 kg)Power RequirementsVoltage Range: -21 to -26VDC "B" BatteryIdle Current: 12mAOperating Current: 15mA Refer to the figure above for connections.Cabling "D" type station wire or other suitable pairsmay be used for audio and power connections.Nominal SpecificationsInput Impedance: 600 OhmsOutput Impedance: 8 Ohms1 947095