Menu
Vaisala MD30 Installation Manual
Also see for MD30: Setup guideSetup guideReference guideInstallation guideUpdating Software
    |
Mounting MD30 on towing hookTo use MD30FRONTMOUNT, you need a towing hook installed on your vehicle as instructed in your carmanufacturer's manual.• MD30FRONTMOUNT mounting adapter• 19-mm wrench• 2.5-mm and 3-mm Allen keys• Torx T15Table 1 MD30FRONTMOUNT contentsPart Pcs Part PcsMounting bracket 2 Rubber sheet 2Torx socket head screw M4×12 8 Metal counterplate 1Mounting block 1 Hex self-lock nut M12 1Countersunk hex socket head screw M4×16 10 Fender washer A5,3 1Hex head bolt screw M12×50 1 Hex socket head screw M5×16 1Shaft 1 Hex socket set screw M6×12 2Mount MD30 on the towing hook with MD30FRONTMOUNT. The measurement angle is automaticallycorrect when the mounting bracket is positioned vertically.199 [7.83]30°Road surfacemm[in]90°Figure 1 Correct measurement angleWhen using towing hook mounting, you can still use MD30EXTSET to mount the air temperature andhumidity sensor HMP113 and surface temperature sensor MT10 elsewhere on the vehicle for optimumperformance. In that case, install them last. See Mounting Temperature Sensors Separately InstallationGuide.M212519EN-AInstallationGuideMounting MD30 on Towing HookVaisala Mobile Detector MD30PUBLISHED BYVaisala OyjVanha Nurmijärventie 21FI-01670 Vantaa, Finland© Vaisala 2020All rights reserved. Any logos and/or product names are trademarks of Vaisala or its individual partners.Any reproduction, transfer, distribution or storage of information contained in this document is strictlyprohibited. All specifications — technical included — are subject to change without notice. |
Related manuals for Vaisala MD30
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved