Menu
VAT videofied XMB611 Installation Datasheet
    | |
Product SummaryThe Indoor Keypad Model XMB611 is designed for use inconfiguring/programming and operating a VideofiedTM securitysystem. The keypad includes the following features:> Lithium batteries for long life.> 2-line, 16-character alphanumeric LCD display> Built-in badge reader for arming/disarming> Built-in piezo for status and alarm sounds> Dual tamper function provides detection of bothwall and cover tamper.> Transmits check-in/status signal every 8 minutes.Installation GuidelinesFor easier installation, programming and RF testingshould be completed before mounting the control panel anddevices.Install the keypad and other system devices in the followingorder:> Programming/RF Testing - Program keypad and all otherdevices into the control panel and test RF communicationfrom each intended device location to the control panel.> Mounting - Mount keypad and devices at the tested location.Programming/RF Testing*1 Open the casing by turning the button toward the openedpadlock symbol and press down lightly on the button toseparate the cover.2 Insert 3 (minimum) or 4 (for longer life) SAFT 3.6v LithiumAA LS14500 batteries.3A New Installation: Put the control panel intokeypad registration mode by pressing theprogramming button of the control panel one time.OR3B Adding to existing system: Using a programmedalphanumeric keypad, proceed through menus until thedisplay shows ADD A NEW DEVICE. Press Yes. Thedisplay shows PRESS PROGRAM BUTTON OF DEVICE.OR3C Adding to existing system without a keypad: Refer tothe installation manual of the control panel.4 Press and release the programming buttons (CLR andESC/NO) on the XMB keypad. The keypad LED will flash.Wait for keypad display to show KEYPAD# RECORDED.5 Press Yes. The display shows LANGUAGE: ENGLISH. PressYes. (This prompt will only appear when performing anew installation).6 Display shows RADIO RANGE TEST? Press YES, thekeypad starts displaying the number of successful pingsto and from the control panel out of 9 (0/9 to 9/9).Devices must be installed in a location with a stable 9/9 RFtest result to ensure reliable communication.7 Press YES to end radio range test, then press Esc/No.Note: If this is a new installation (3A), the keypad displayprompts other system configuration data. If adding a keypad toan existing (operational) system, proceed to step 8.8 When finished, exit from configuration mode.Note: The control panel automatically assigns alphanumerickeypads automatically to Area 1 (Entry/Exit delay)*For complete details, refer to the control panel installation manual.I N S T A L L A T I O N D A T A S H E E TMade by RSI VIDEO TECHNOLOGIES 1010-XMBIN February 2012Keypad |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved