VAT PM-4 Installation, Operating And Maintenance

Contents

VAT PM-4 Installation, Operating And Maintenance Manual pdf 3 page image

certifiedQM-Systemgeprüft esQM-SystemISO 9001EN 29001Installation, Operating, and Maintenance InstructionsSeries 64.1VAT Vakuumventile AG, CH-9469 Haag, SchweizTel ++41 81 771 61 61 Fax ++41 81 771 48 30 Email reception@vat.ch http://www.vatvalve.com225590EE2005-04-26 3/16Confirm that hardware is complete (picture 1)(1) Adaptive Pressure Controller PM-4 or PM-5, hereafter referred to as PM controller.For PM controller with power failure option confirm that battery life has not expired (see chapter ‚4 Preventive Maintenance‘)(2) Connection cable valve - PM controller: VAT part number 640CV-99L .(3) VAT Series 64 control valve(4) Mains connection, wiring information see chapter ‚9.1.2 Connector for mains‘(5) Interface cable, wiring information see chapter ‚9.1.3 Connector for interface‘(6) Sensor 1 (standard) and 2 (option)(7) Cable for sensor 1 and 2, wiring information see chapter ‚9.1.1 Connector for sensor 1 and sensor 2‘Install hardwarePM controller must be switched off during installation.- Install VAT control valve (3) according to the Installation, Operating and Maintenance Instruction Manual of the VAT Series 64 controlvalve.- Install sensor(s) (6) according to the recommendations of the sensor manufacturer- Install PM controller (1) into control rack.- Connect valve cable (2) to control valve and then to PM controller (connector: valve)- Connect sensor cable (7) to sensor(s) and then to PM controller (connector: sensor 1 / sensor 2)- For remote operation, connect interface cable (5) to PM controller (connector: interface)- Connect mains cable (4) to PM controller