VARO POWERPLUS POWX07595 Manual

VARO POWERPLUS POWX07595 Manual Manual pdf 1 page image

POWX07595 ENCopyright © 2020 VARO P a g e | 1 www.varo.com1 APPLICATION .................................................................................. 32 DESCRIPTION (FIG. A) ................................................................... 33 PACKAGE CONTENT LIST ............................................................. 34 DDITIONAL SAFETY INSTRUCTIONS ........................................... 44.1 Guard related warnings .......................................................................................... 44.2 Cutting procedures warnings................................................................................. 44.3 Kickback causes and related warnings ................................................................. 44.4 Table saw operating procedure warnings ............................................................. 55 SAFETY EQUIPMENT ..................................................................... 55.1 Cleaving wedge ....................................................................................................... 55.2 Saw blade protector ................................................................................................ 55.3 Push stick ................................................................................................................ 56 UNPACKING AND ASSEMBLY ...................................................... 56.1 Assembly (Fig. 1) .................................................................................................... 66.2 Attaching the tilt protection (Fig. 2) ....................................................................... 66.3 Fitting the parallel fence (Fig. 3)............................................................................. 66.4 Mounting mitre angle stop (Fig. 4) ......................................................................... 66.5 Mounting the saw blade guard (Fig. 5) .................................................................. 66.6 Mounting the extraction hose (Fig. 6) .................................................................... 67 OPERATION ..................................................................................... 77.1 Check before starting the device! .......................................................................... 77.2 Operating elements................................................................................................. 77.2.1 On/off switch ............................................................................................................. 77.2.2 Overload Protection (18) ........................................................................................... 77.2.3 Setting mechanism for the tilt angle........................................................................... 77.2.4 Hand crank for setting the cutting height ................................................................... 77.3 Workpiece stops ..................................................................................................... 77.3.1 Mitre angle stop ........................................................................................................ 77.3.2 Mitre cuts (Fig. 7) ...................................................................................................... 87.3.3 Setting the stop rail of the parallel stop ...................................................................... 87.3.4 Parallel stop .............................................................................................................. 8