VADDIO WallVIEW CCU HD-19 Installation And User Manual

Also see for WallVIEW CCU HD-19: Installation and user guide Installation and user guide Installation and user guide Installation and user guide Installation and user guide

Contents

general specifications

VADDIO WallVIEW CCU HD-19 Installation And User Manual Manual pdf 11 page image

WallVIEW CCU HD-19WallVIEW CCU HD-19 Manual 342-0268 Rev. A Page 11 of 20Basic Installation Instructions:Step 1:After determining the optimum location of the camera system, route the required 3(three) Cat-5e cables from the camera to the Quick-Connect CCU interfacelocated at the head-end. The three Cat-5e cables should feed-through the ovalslot located on the rear flange of the wall mount. If the bracket is to be mountedon a 2-gang wall box, use the screws supplied with the wall box cover plate toattach the Thin Profile Wall Mount. If mounting to the drywall with wall anchors,use four (4) provided drywall anchors. The mounting holes are slotted and are90° opposing to provide easy leveling. Level the mount and tighten down themounting screws.Step 2:Remove the blank panel below the connectors on the back of the camera. Slidethe EZIM CCU Card into the slot on the back of the camera until the connector isseated into the camera. Tighten the thumb screws on the EZIM CCU Card.Yet Another Note About the IR OUT Dip Switch 4:When operating the HD-19 camera with the Quick-Connect CCU, the IR OUT dip switch must beset to the OFF (up) position on the back of the camera. If it is not turned off, it can and willinterfere with proper operation of the HD-19 PTZ camera.Step 3:Follow the sample wiring diagram on the previous page for connecting the Cat-5e from the Quick-Connect CCU tothe camera. Additional diagrams are available on our website for installation with other equipment.IMPORTANT NOTE: Check all Cat-5e cables for continuity in advance of the finalconnection. Plugging the POWER Cat-5e Cable into the wrong RJ-45 may cause damage tothe camera system and void the warranty.Step 4:Place the camera onto the camera mount, connect the previously marked cables to their proper jacks (please donot guess - especially on the power Cat-5e). Slide the camera back onto the mount and “stuff” the extra cableback into the wall cavity (dress the cabling) and use the provided ¼” x 20 screws to attach the camera to themount securely.Step 5:Connect the Vaddio 36 VDC, 2.78A power supply to the Quick-Connect CCU and AC side the into an AC outlet.Power will travel down the Power Cat-5e cable to the camera. The camera will “Home” to a centered positionready for control information from CCU and the camera controller (ProductionVIEW HD or maybe the PrecisionCamera Controller). To ensure proper continuity of control and operation of the cameras, the boot order shouldbe camera first (cameras are always first), the Quick-Connect CCU and lastly, the controller.Step 6:Set-up the CCU: Make sure that the HD video monitor that you are using is set up correctly and is delivering accurate colorreproduction. Adjust the iris level of the camera so that brighter areas are not washed out. Adjust the Red & Blue Gain, Gamma, Detail and Chroma controls. Adjust other parameters to taste..NOTE: Gain (next to Iris) should be left at 0 (zero), unless lighting is inadequate, then turn it to a level where thesignal brightness is at an appropriate level. Gain adds additional noise (grain) to the video the higher it is turnedup.Thin ProfileCameraWall MountEZIM CCUSlot Card