VADDIO RoboSHOT 12 Installation And User Manual

Also see for RoboSHOT 12: Installation and user guide User guide Installation and user guide Installation and user guide Release Notes & Update Instructions

Contents

VADDIO RoboSHOT 12 Installation And User Manual Manual pdf 16 page image

RoboSHOT HD CamerasRoboSHOT HD Cameras - Document Number 342-0796 Rev C Page 16 of 68Step 5: With camera set to rotary resolution position “0”, the camera should boot up and output the 720p/59.94out of the HDMI and the YPbPr output connectors On the Quick-Connect USB. Once the video output is achieved,then setting up the RoboSHOT camera and Quick-Connect USB webpages are next. But first, let’s look at theabundant methods of control for the camera and interface.CONTROLLING THE CAMERAIR Remote CommanderThe following functions are accessible with the Vaddio IR remote: Camera Power On/Off (Toggle on/off same button) Back Light Compensation (Toggle on/off same button) Data Screen: Toggle on/off the OSD for the RoboSHOT’s IP/MAC Address Camera Select (the remote can operate 3 cameras (with 3-IR Freq.) Pan/Tilt and Home controls with Reverse and Std. Pan direction Pan/Tilt Reset Auto Focus (Toggle on/off same button) Zoom In/Out controls Wide & Telephoto Fast speed controls (W & T) Slow speed controls (W & T) Manual Focus On/Off control (Toggle on/off same button) Near (-) adjustment Far (+) adjustment Six (6) pan/tilt/zoom positioning presets (1 through 6) Preset Set (store) Preset Reset (clear) Red LED that indicates IR Transmission and battery levelThe IR Remote operational characteristics are as follows: Preset Activation: IR Remote is limited to executing Presets 1 through 6. Tri-Sync Speed on Preset: If a global Tri-Sync speed is stored in the preset in the internal web pages by theuser/admin, then that speed is used. If no Tri-Sync speed is used, then a default medium speed will be used. Preset Store: IR Remote is limited to positional (PTZ) type presets. To set a preset, position the camera, holddown the Preset Button and touch the one of the preset numbered buttons 1 through 6.Telnet ControlThe following *Telnet commands are available through the Ethernet Port. Camera Home Camera Pan (left, right and speed - real-time operation) Camera Tilt (up, down and speed - real-time operation) Camera Zoom (zoom in/out/stop and speed - real-time operation) Camera Store Preset (Gets or Sets 12 presets with global relative PTZ [Tri-Sync] speed control to destination) Camera Image (Gets or sets current image control values, sets in 1 of 3 CCU presets)(AWB or manual w/Red and Blue gain, BLC on/off, Auto Iris or manual with Iris value and Gain, Detail and Chroma) Camera Sleep (Gets or sets standby power mode - camera has to us less power in this mode) Exit (ends Telnet session) Help (displays CLISH syntax) History (command history) Network Ping (send ICMP ECHO_REQUEST to network hosts) Network Settings (Gets MAC address, IP address, Subnet Mask, Gateway and NTP server address) Network (Gets the current network settings or pings an IP address) **Streaming Mode - USB or IP needs to be changed to USB and IP (get and set streaming modes, on/off) **Streaming Quality (gets/sets high/standard/low for IP) **Streaming Resolution (gets/sets streaming resolution) **Streaming (gets/sets current streaming settings) System Factory Reset System Reboot Version (system version information)*Please see the full Telnet command list at the end of this manual.**Streaming Controls are located within the Quick-Connect USB Interface web server.VaddioIR RemoteCommander