Uplift Desk MON041 Manual

Also see for MON041: Quick start guide

Uplift Desk MON041 Manual Manual pdf 1 page image

© UPLIFT Desk • 800-349-3839 • info@upliftdesk.com • upliftdesk.com1Package ContentsEnfield Single Monitor ArmSKU: MON041Package ContentsAllen Wrenches(set of two: 4mm, 6mm)Lower ArmWire CoverUpper ArmLower ClampVESA PlateUpper ClampM5x12 Screw (M-B) (qty 4)M5 Washer (M-C) (qty 4)M4x12 Screw (M-A) (qty 4)M6x12 Flathead Screw (qty 3)Flat WrenchBaseLower armUpper armVesa mount (x1)Lower base plateUpper base plateBar HandleAdhesive PadWire CoverUpper ClampLower ClampBase screw (x4)3mm Allen wrenchL4mm Allen wrenchM6mm Allen wrenchND5 Washers (x4)M5x12 bolt (x4)M4x12 bolt (x4)O Bolt (x4)N Bolt (x4)BaseLower armUpper armVesa mount (x1)Lower base plateUpper base plateBar HandleAdhesive PadWire CoverUpper ClampLower ClampBase screw (x4)3mm Allen wrenchL4mm Allen wrenchM6mm Allen wrenchND5 Washers (x4)M5x12 bolt (x4)M4x12 bolt (x4)O Bolt (x4)N Bolt (x4)BaseLower armUpper armVesa mount (x1)Lower base plateUpper base plateBar HandleAdhesive PadWire CoverUpper ClampLower ClampBase screw (x4)3mm Allen wrenchL4mm Allen wrenchM6mm Allen wrenchND5 Washers (x4)M5x12 bolt (x4)M4x12 bolt (x4)O Bolt (x4)N Bolt (x4)BaseLower armUpper armVesa mount (x1)Lower base plateUpper base plateBar HandleAdhesive PadWire CoverUpper ClampLower ClampBase screw (x4)3mm Allen wrenchL4mm Allen wrenchM6mm Allen wrenchND5 Washers (x4)M5x12 bolt (x4)M4x12 bolt (x4)O Bolt (x4)N Bolt (x4)BaseClamp Method Bolt-Through Method• Acceptable monitor weight range: 4.4 lb to 19.8 lb• Desktop thickness compatibility:• Clamp Method: 0.4”-3.3” thick.• Bolt-through Method: 0.4”-3.1” thickThere are two ways to attach the Enfield Single Monitor Arm to your desktop. If you would like to attach it along the backedge of your desktop, follow the Clamp Method instructions starting on this page. If you prefer to attach it through yourdesktop, follow the Bolt-Through Method instructions starting on page 2.Step 1Determine your mounting method. There are twoways to attach the Enfield Single Monitor Arm to yourdesktop:Clamp Method: If you would like to attach the monitorarm along the back edge of your desktop, follow theClamp Method instructions (Steps 2 - 4).Bolt-Through Method: If you prefer to attach themonitor arm through your desktop, skip Steps 2 - 4and follow the Bolt-Through Method instructions(Steps 5 - 7).Step 2 (Clamp Method)Align the Upper Clamp with the Base in the orienta-tion shown and attach it using the three M6x12 Flat-head Screws and the 4mm Allen Wrench.Clamp MethodParts forBolt-through assemblyUpper Base PlateLower Base PlateLong BoltM8 WasherM8 Nut