Uplift Desk CPU128 Instructions Manual

Uplift Desk CPU128 Instructions Manual Manual pdf 1 page image

Track guardTrack Back bumperUPLIFTCPU HolderTrack Spacer Kit(optional)5/8’’ Wood screws(qty 12)Allen wrenchUPLIFT Desk • 1-800-349-3839 • info@upliftdesk.com • www.upliftdesk.comPackage contents®CPU HolderCPU128Step 1Hold the Track under your desk to see where it will fit. Mark the locationof the screw holes with a pencil.*A note before you begin:Determine where to mount the CPU Holder. If you need to mount itover the Crossbars of your desk, open the box containing the TrackSpacer Kit and follow the instructions inside.Step 2Use a drill with a 1/8” bit and drill your pilot holes where your two pencilmarks are located. Drill no deeper than 1/2’’.CAUTION: Do not drill through the desktop surface.Step 3Make sure screws aren’t too long for your desktop thickness by holdingthe screw up to the desktop side. Attach the track to the underside ofthe desk by using eight (8) Wood screws and a Phillips head screw-driver.Step 4Using one (1) Wood screw, attach the rubber Back bumper to the rearside of the track.Step 5Use the Allen wrench and loosen the three (3) bolts on the side of theCPU holder. This will loosen the lower half of the vertical clamp, andallow you to slide it to its full height.CPU128/R01

/ 2

Related manuals for Uplift Desk CPU128