Unitronics V350-35-RA22 Installation Manual

Also see for V130-33-RA22: Installation guide User guide

Contents

Unitronics V350-35-RA22 Installation Manual Manual pdf 2 page image

V350-35-RA22 Installation Guide2 UnitronicsRemovableMemory StorageMicro SD card: store datalogs, Alarms, Trends, Data Tables; export to Excel;backup Ladder, HMI & OS and use this data to ‘clone’ PLCs.For more data, refer to the SD topics in the VisiLogic Help system.Data Tables Data tables enable you to set recipe parameters and create datalogs.Additional product documentation is in the Technical Library, located at www.unitronics.com, and onthe Unitronics’ Setup CD.Technical support is available at the site, and from support@unitronics.com.Standard Kit ContentsVision controller Mounting brackets (x2)I/O connectors (x2) Rubber sealBattery (installed) 2 sets of key label slidesProgramming cable + RS232 adapter Unitronics’ Setup CDDanger SymbolsWhen any of the following symbols appear, read the associated information carefully.Symbol Meaning DescriptionDanger The identified danger causes physical and property damage.Warning The identified danger could cause physical and property damage.Caution Caution Use caution. Before using this product, the user must read and understand this document. All examples and diagrams are intended to aid understanding, and do not guarantee operation.Unitronics accepts no responsibility for actual use of this product based on these examples. Please dispose of this product according to local and national standards and regulations. Only qualified service personnel should open this device or carry out repairs.Failure to comply with appropriate safety guidelines can cause severe injury or property damage. Do not attempt to use this device with parameters that exceed permissible levels. To avoid damaging the system, do not connect/disconnect the device when power is on.Environmental Considerations Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,moisture or rain, excessive heat, regular impact shocks or excessive vibration, in accordancewith the standards given in the product’s technical specification sheet. Ventilation: 10mm space required between controller’s top/bottom edges & enclosure walls. Do not place in water or let water leak onto the unit. Do not allow debris to fall inside the unit during installation. Install at maximum distance from high-voltage cables and power equipment.i4 Automation Ltd - 01480 395256