Menu
Unicorp Computer ENDAT-GX201 User Manual
                                 | |
Contents
| 
ENDAT-GX201 USER’S MANUALUNICORN COMPUTER CORP.515-2. UTP Cable / RJ-45 Jack DefinitionStraight through twisted pair cable is typically used to connect a hub to a server or workstation.In a straight through connection, Pin 1 at the server, Pin 2 at the hub connects to Pin 2 at theserver, and so on. Figure A-1 shows the locations of pins on a standard RJ-45 plug on atwisted-pair cable.Table A-1 shows the wiring in a straight-through twisted-pair cable (Pins 4, 5, 7 and 8 are notused).Twisted PairNumber Pin Number SignalDescription To Pin Number SignalDescription1 12TD+TD– Æ 12TD+TD–2 36RD+RD– Æ 36RD+RD–Table A-1Figure A-1ENDAT-GX201 USER’S MANUALUNICORN COMPUTER CORP.525-3. Connecting 100Base-TX Fast Ethernet NetworkTo connect the adapter to 100Base-TX Fast Ethernet Network, you need a twisted-pairCategory 5 cable with RJ-45 modular jacks at both ends. This cable can have a maximumlength of 300 feet (100 meters).5-4. Remote BOOT ROM functionThis function is available with the BIOS programming for indicated operation system. Theremote boot function allows the computer to boot up over the network, instead of using thelocal operating system device. This enables the system to be a diskless workstationenvironment.5-5. Diagnostic Program (RSET8139)This program allows you to verify the configuration and isolation of faults.Program (RESET8139.exe) provides the following function:• Displays the current configuration of the adapter• Performs network diagnostic tests to verify the operation of the adapter’s basicfunctions, and the adapter’s ability to communicate over the network with anotheradapter.• Provides set up for new configuration to make a change specify settings: RemoteBOOT ROM, Flow Control and Full-Duplex mode Enable/or DisableFull duplex operation is set automatically if the Full-duplex option is set to Disable. Pleasefollow the prompt instructions to set-up or change the system configuration.Note: Before running the setup program, make sure the adapter’s driver is not loaded,otherwise unpredictable results may arise!The program can be set the on board configuration to provide diagnostic testing. It is fortesting the basic function verification, EEPROM data Access, loop back operation, and theability to communicate over the network with another adapter. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved