Uni-bond E-2111AC-M User Manual

Uni-bond E-2111AC-M User Manual Manual pdf 1 page image

Remove the mounting plateInsert the hex bolt in placeUSER MANUALPart No. E-2111AC-MFlash PatternsWARNING:It is not recommended to use magnetically mounted warning devices on outside of vehicle in motion.Usage is at the sole risk and responsibility of the user.NO. Flash Patterns12345678910116-FlashDouble FlashSingle Flash - SAE Class 1Mega FlashRotating Flash (Quick)**Alternating Left & Right Mega FlashAlternating Left & Right Single FlashRotating Flash (Slow)**Alternating Diagonal 6-FlashAlternating Diagonal Double FlashRandomNote : Disassembling lamp will void the warrantyDO NOT use a high pressure power washer to clean your E-2111AC-M, this may damage your E-2111AC-M and voidits warranty.For more information, visit our website at: www.unibondlighting.comON/OFF SwitchFlash Pattern Button- Once to the next pattern- Three times in quick succession forFlash Pattern NO. 1Momentarily press the buttonFlash Pattern buttonON/OFF buttonMounting (Single Bolt)Remove the 4 screws on themounting plate in the centreStep 1 Step 2Insert the mounting plate on topMount in place with the 4 screwsStep 3**Rotating Flash: switching between CW & CCWPress [ Flash Pattern ] button 5 times in quick successionSwitch #1ST307(OFF-ON-Momentary ON)Jumper WiresFrom Battery PositiveGroundPowerPattern SelectionBattery GroundRedBrownWhiteSuggested Switch Connection (switches sold separately)**Note: This info is only for hardwire option. User/Installer isresponsible for any damages done when deciding to removethe cigarette adapter in order to expose individual wires.Last Updated: 09/12/2023Wire Colour Function Connect ToRedWhiteBrownPowerGroundPattern Selection+12/24 VDC (Power)- (Ground)+12/24 VDC (Power)Light should be fused with 5 Amp Fuse (ATM05 sold separately)Wiring Information

/ 2

Related manuals for Uni-bond E-2111AC-M