Ultimate Ears MEGABOOM Faq

Also see for MEGABOOM: Software instructions How do How-to guide

Ultimate Ears MEGABOOM Faq Manual pdf 1 page image

How do I charge my Ultimate Ears speaker?To recharge your Ultimate Ears speaker, plug the included charging cable into the micro-USBport located inside the weather door. Use the included power supply and USB cable forquickest recharge. Never charge your speaker if the micro-USB port, charging cable orconnectors are wet, dirty or damaged. If you’ve used your speaker in a swimming pool or theocean, we highly recommend that you thoroughly rinse your speaker with fresh water afterusing it. Once clean, allow the speaker to air dry completely before charging it. While thespeaker is waterproof, the chemicals and salt in your pool or the ocean can damage thewaterproof seals over time if not rinsed off after use. The micro-USB charging cable includedwith your speaker is not waterproof. Always charge your speaker with a clean, dry micro-USBconnector. If you think your cable or connector has been compromised in any way by water orother contaminants, do not use it to charge your speaker. Contact us for a replacement cable.Do I need to clean my Ultimate Ears Speaker after using it in or around water?While we encourage you to take your Ultimate Ears Speaker wherever the party goes, we alsowant it to look great and last as long as possible. We highly recommend that you thoroughlyrinse your Ultimate Ears Speaker with fresh water after using it in a swimming pool or theocean. Once clean, allow the speaker to air dry completely before charging it. While thespeaker is waterproof, the chemicals and salt in your pool or the ocean can damage thewaterproof seals over time if not rinsed off after use. The micro-USB charging cable includedwith your Ultimate Ears Speaker is not waterproof. Never charge your Ultimate Ears Speaker ifthe micro-USB port, charging cable or connectors are wet, dirty or damaged. Always chargeyour speaker with a clean, dry micro-USB connector. If you think your cable or connector hasbeen compromised in any way by water or other contaminants, do not use it to charge yourspeaker. Contact us for a replacement cable.My MEGABOOM no longer charges, how do I fix it?Your MEGABOOM can sometimes get into a state where it doesn’t charge. To get your MEGABOOMback to a normal charging state, do the following:1. Connect your speaker to the charger and leave it connected for a few seconds.2. If the charge LED fails to pulse continuously, disconnect the cable from your speaker, thenreconnect it, and leave it connected for a few seconds.3. Repeat steps 1 and 2 until your speaker gets to a normal charge cycle - the LED should continueto pulse. (This could take up to 25-30 times.)4. Once your speaker gets to a point where it charges normally, continue to charge it until thebattery is at 100%.