Ublox ODIN-W2 Series Getting Started

Also see for ODIN-W2 Series: System integration manual

Ublox ODIN-W2 Series Getting Started Manual pdf 11 page image

ODIN-W2 series - Getting StartedUBX-15017452 - R02 Advance Information Evaluation boardPage 11 of 274.2 Restore default serial settingsIf the Restore/Function button is pressed during power on, the module resets the serial settings and escapesequence to the default values.• Default serial settings is 115.2 kbps, 8N1 and HW flow control enabled• Default escape sequence is +++• Default escape sequence timing is 1s silence before and after escape sequence4.3 Restore factory settingsIf both the default serial settings and the external connect button is pressed during power on, the factorysettings are restored. You can also restore to factory settings using the AT+UFACTORY command followed bypower off/on.