Menu
UTIFORM HD 50/07 Instruction Book
                                                                                                                                            | |
Contents
| 
Floor Screed Machine HD 50 13www.utiform.com departamento.técnico@utiform.com Tfno. + 34 96 570 29 82 Fax: + 34 96 570 29 83Do not carry out welding work on the axle.3.3.9 Pneumatic WheelsWhen changing the wheel, ensure that the correct axle housing corresponds to the wheel couplings.• Tighten the ball screws with the turning moment marked• The tires should correspond with the axle specifications.3.3.10 Inertia brakeOnly have brakes repaired in an authorized garage and only use original partsThe wheel brakes fulfill the regulations on toxic substances and EU regulations.3.3.11 Brake supports and blocksFix the wheels with both brake blocks, both on flat surfaces as well as on slopes to prevent the vehicle fromrolling.3.3.12 Trailer lights systemThe light bar is available in the version for 7 pole plug from 12 V and 24 V. This light system is assembledas follows:• Take the light bar and place it at the back of the machine, attaching it with the two spring pinsdesigned for the purpose.• Take the lighting cable with its normalized pug for the lighting bar, and connect to the 7 port base onthe side of the machine.• Connect the plug to the front of the trailer in the area of the tow shaft and connect it to the tractionvehicle.• For dismantling carry out the process in reverse.If a 12 V traction vehicle is used, the cable may be immediately connected to the vehicle.If a 24 V traction vehicle is used, a 12 V to 24 V adaptor is required (consult us providing item reference)If driving a vehicle with a EURO plug, 12 V to EURO adaptor is required (consult us providing itemreference) |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved