USFleetTRacking USFT NT-V3 Install Manual

USFleetTRacking USFT NT-V3 Install Manual Manual pdf 1 page image

Install NT-V3The USFT NT-V3 Install GuideWe recommend installation of your device by a professional installer.Please verify that your device is activated prior to installation. Whenactivating a unit, refer to the device MID# on the underside of thetracking device. (Reference Image A.)The NT-V3 requires a standard 3-wire installation to operate effectively.Please familiarize yourself with the following wire colors and functions.The red wire (power) should be directly wired to a constant 7V - 32V power source found at thekey source or fuse panel.The black wire (ground) should be securely fastened to a grounded screw or to chassis ground.The white wire (ignition) is the ignition event wire that is installed directly to the ignition wire.Ensure that power to the ignition wire is available ONLY when the vehicle ignition is turned on. Allmakes and models of vehicles are different - we recommend you make sure that you know yourparticular vehicle’s Constant and Ignition wires and their specific color(s) prior to installation.The green, brown and yellow wires (outputs) can be used to honk the vehicle’s horn, unlock its doorsremote start the engine, and disable/enable the starter.The blue, orange, purple, and grey wires (input) can be used to monitor many functions such as PTOactivity (Power Take Off), emergency lights, panic switch, etc or a specified input for the customer.Step 1: Wiring and Installation405.726.9900 | 2912 NW 156th Street | Edmond, Oklahoma 73013 | www.usfleettracking.comThank you for purchasing your new GPS vehicle tracking system!Installation of your new GPS tracking device couldn’t be easier.Just follow these simple steps.Step 2: Status LED LightsAfter installing the unit, and prior to securing under the dash area, make surethe unit has a solid green light and a blinking orange light that goes solid for 1second, then repeats the pattern. See table on page 2 of this Installation Guidefor troubleshooting when one or both does not occur.(Reference Image B and Table on Page 2.)Image AImage BtRed wireBlack wireWhite wireGreen wireBrown wiretttttttttttttttttttt12 VDC constantGroundKey (on)Output (150 mA)Output (150mA)* Must be connected for device to work properly.***Unlock DoorInput (panic)p (p )InputInputInputYellow wireBlue wireOrange wirePurple wireGrey wireOutput (150 mA)Input - Bias lowInput - Bias highInput - Bias highInput - Bias highNTIGv3.8

/ 2

Related manuals for USFleetTRacking USFT NT-V3