U-Line H-1335 Manual

Also see for H-1335: Quick start guide

U-Line H-1335 Manual Manual pdf 1 page image

PAGE 1 OF 9 0424 IH-1335H-1335KIHLBERG PNEUMATICROLL FEED STAPLER1-800-295-5510uline.comWARNING! Read all warnings and instructions toprevent injuries to yourself and to others.• Use only original Kihlberg R555, R556 or R557 rollstaples with 15 or 18 mm leg length.• Wear eye protection when using tool. Always useother personal protection equipment as required,such as ear protection, hard hats, etc.• Never use oxygen, combustible gases, CO2, steamor high pressure gas tanks as power sources for thePN-version of this tool; the tool may explode andcause serious injury. Use only dry, clean, pressureregulated compressed air to drive the tool.• Always assume stapler is loaded. Never point atyourself or anyone else. Always remove finger fromtrigger when not stapling.• Always disconnect the tool from the air supply andempty the magazine when taking a break or endingwork, when servicing the tool, troubleshooting orrepairing. Never leave a loaded tool unattended.• Always check tool before every use.• Never hold your hand or another part of your bodyunder the tool.• Position yourself in a firmly balanced position whenusing or handling the tool.• Do not modify the tool or set it up in a jig withoutmanufacturer's approval.• Use stapler with cardboard only. No other use ispermitted without the approval of the manufacturer.Para Español, vea páginas 4-6.Pour le français, consulter les pages 7-9.SAFETYOPERATIONATTACH COMPRESSED AIRCAUTION! Ensure the tool is not pointed atyou or anyone else when connecting it to thecompressed air line.NOTE: The maximum permitted air pressure forthe tool is 8 bar (116 psi). The maximum supplypressure is 8.78 bar (127 psi).Connect the tool to the compressed air system beforethe fastener unit is loaded.NOTE: The tool and its hose can be equippedwith a connection nipple (not included) thatautomatically exhausts air from the tool after ithas been disconnected.Ensure the minimum internal diameter of the air hose is10 mm (3/8") and that of the nipple is a minimum of5 mm (6/32"). This prevents incorrect operation due toexcessive pressure drop.AIR PRESSUREAdjust the air pressure to the lowest setting that will bendthe staples correctly.1. Start at 5.0 bar (72 psi).2. Raise pressure by 0.5 bar (7 psi) increments untilcorrect pressure for the job is found.CAUTION! Never exceed 8 bar (116 psi).TOOL NEEDED2.5 mm Allen Wrench