U-Line H-1276 Instruction Manual

Also see for H-1276: Manual

U-Line H-1276 Instruction Manual Manual pdf 1 page image

PAGE 1 OF 6 0922 IH-12761-800-295-5510uline.comAUTOMATIC LABELDISPENSERH-1276, H-1981SETUP1. Remove 1" collar with thumb screw (A) from rollholder bar (B). (See Figure 1)2. Install one core insert onto roll holder bar (B).(For labels with 3" cores.)NOTE: For rolls with cores smaller than 3", followthese instructions but do not use core inserts.3. Add a roll of labels onto roll holder bar and attach itto core insert. The labels should unwind toward frontof machine.4. Fit second core insert into opposite side oflabel core (C).5. Re-attach 1" collar with thumb screw (A) onto roll holderbar (B). Tighten screw to hold all items securely inplace.THREADING LABELS1. Remove labels from first two feet of liner.2. Thread two feet of liner under guide bar (D)and between the dispenser bar (E) anddispenser plate (F). (See Figure 2)3. Remove spring clip (G) from the take-up spool (H).Pull empty liner back over top of and wrap aroundtake-up spool. Replace spring clip while holding theliner tight.4. Adjust the side guide (I) on the guide bar to ensurelabel is secure and does not move.Para Español, vea páginas 3-4.Pour le français, consulter les pages 5-6.Figure 1BCAFigure 2FHDE IG