U-Line H-1130 Manual

U-Line H-1130 Manual Manual pdf 1 page image

PAGE 1 OF 2 0715 IH-1130π H-1130, H-3476BULK SOAP DISPENSERS1-800-295-5510uline.comINSTALLATIONOPENING THE DISPENSER1. To open the dispenser lid, insert key into slot at back,right side of lid and push in on key. (See Figure 1)2. Back lid will pop off. (See Figure 2)GENERAL MOUNTING INSTRUCTIONS• Use the included tape on glazed tile, painted metalor unpainted metal walls. Tape will not performsatisfactorily if wall surface is porous like brick orwood.• On all other wall surfaces, use screws and anchors(not included) or other appropriate hardware basedon surface type.• Locate dispenser above a sink or counter.Recommend never locating where spillage can fallon floor creating hazardous conditions.• Installer will be held responsible for properinstallation.• To be in compliance with ADA regulations, thedispenser should be mounted no more than 48"from the ground.MOUNTING WITH DOUBLE-SIDED TAPE1. Thoroughly clean wall surface and let drycompletely. For silicone build-up, use a pumice-type cleaner or grout cleaner to clean the surface.2. Peel off paper from back of tape (supplied). Pressdispenser firmly to the wall and hold for at least 30seconds to make sure tape has completely adheredto the wall. (See Figure 3)3. Wait 24 hours before filling with soap to ensure thatthe tape has completely adhered to the wall beforeadding weight.MOUNTING WITH SCREWSAND ANCHORS (NOT INCLUDED)1. Remove lid (as described previously). Push latch outand detach dispenser from back plate.(See Figure 4)2. Using the back plate as a template, mark holelocations on wall.3. Drill 3/16" diameter holes for anchors and screws orother hardware. Attach dispenser to back plate andreplace lid.Figure 1Figure 3 Figure 4Figure 2

/ 2

Related manuals for U-Line H-1130