PAGE 1 OF 6 1123 IH-112691-800-295-5510uline.comWATER JUG RACKSH-11269, H-11270Para en Español, vea páginas 3-4.Pour le français, consulter les pages 5-6.Figure 3ASSEMBLYPARTSFigure 2POST ASSEMBLY1. Connect post tops to post bottoms with a post connector. (See Figure 1)NOTE: Post tops have a black plastic cap in the top of the post.SELF-LEVELING FEETNOTE: If installing casters, do not install self-levelers.1. Make sure post is positioned as shown. (See Figure 2)2. Insert self-levelers into open end of post. Use a rubber mallet/hammer ortap on ground to slide self-leveler into post.3. Repeat step 2 for all other posts.UNIT ASSEMBLY1. Start with the lowest shelf. Snap the interlocking pieces of a shelf support(wide end down) around the post at the lowest groove where shelf is to belocated. Slide the support up or down until it snaps onto the groove. Adda shelf support to the same place on the remaining posts. (See Figure 3)NOTE: NSF requires food service applications to keep thelowest shelf at least 6" above the floor.TOOL NEEDEDRubber MalletSelf-Leveling Foot x 4 Post x 4Shelf x 2Frame x 2 Shelf Support x 16 SetsFigure 1