U-Line H-1036 Manual

Also see for H-1036: Manual

U-Line H-1036 Manual Manual pdf 2 page image

PAGE 2 OF 18 0316 IH-1036INSTALL WATER RESERVOIRBefore using the dispenser: Wash the moistening brushwith soap and water. Rinse thoroughly.1. Insert the brush in the water reservoir. (See Figure 1)2. Switch power on.NOTE: Make sure top heater is switched OFFand no tape is loaded.3. While holding down the green Random Lengthbutton, take the reservoir in your left hand and insertthe pivot shaft into the slots on sides of dispenser.Move shaft up to the top of the slots. (See Figure 2)4. Slide reservoir down so bottom fits over tabon dispenser.5. Release the green button.INSTALL BRACKETS FOR WATER BOTTLE1. Mount the bottle brackets on left side of machine,inserting first the upper tooth in top slot (C) then thelower one until it locks (D). (See Figure 3)FILL WATER BOTTLE1. Remove bottle from brackets and turn over so filleropening faces up. (See Figure 4)SETUP INSTRUCTIONSFigure 1ReservoirPivot ShaftSlotsRandom LengthButtonFigure 2 Figure 4WATERCDFigure 3CAUTION! Only trained personnel should beallowed to operate or service this machine.WARNING! Burn Danger – Switch off power,unplug the dispenser and allow the top heaterto cool down before performing any cleaning,maintenance or repair.Follow all safety and operating instructions contained inthis manual. Check state and local safety andelectrical codes.NOTE: Tape dispenser is for use with gummedtape ONLY. Uline accepts no responsibility fordamage due to improper use.Check Voltage – Verify that machine voltage and powersupply voltage are the same before plugging inthe dispenser.Keep the machine clean, dry and in good operatingcondition. DO NOT place or operate machine in dampor humid environments.GENERAL INFORMATION