U-Line CLR2160 STAINLESS Use And Care Manual

Also see for CLR2160: Service manual Installation instructions Installation instructions Supplementary guide Install guide

Contents

U-Line CLR2160 STAINLESS Use And Care Manual Manual pdf 10 page image

8 U-Line Ice MakerCleClear Ice Maker Cleaning CycleInterval - Every 3 MonthsTo maintain operational efficiency, clean the unit every threemonths (depending on water conditions, more or less frequentcleaning may be necessary). If the ice maker requires morefrequent cleaning, consult a qualified plumber to test the waterquality and recommend appropriate treatment.IMPORTANTIMPORTANTWear rubber gloves and safety goggles and/or face shieldwhen handling Ice Machine Cleaner.CAUTIONUse only U-Line Ice Machine Cleaner (Part No. 41978,available from your dealer or direct from your local partsdistributor. To locate a parts distributor near you, visitwww.U-LineService.com. It is a violation of federal law touse this solution in a manner inconsistent with its labeling.Use of any other cleaner can ruin the finish of theevaporator and will void the warranty. Read andunderstand all labels printed on the package before use.U-Line Ice Machine Cleaner is used to remove lime scale and othermineral deposits. Refer to the following steps to initiate the self-cleaning cycle.IMPORTANTIMPORTANT• Model CLRCO2175 refrigerator will not operate duringthe ice maker cleaning cycle. Remove all fresh food toprevent spoilage.• Model CLRCO2175 ice production after the firstharvest may take longer after the cleaning cycle sincerestoring the refrigerator temperature will takeprecedence over ice production. Once the refrigeratorreaches its set-point temperature, ice making willresume.CAUTIONNever use anything to force ice from the evaporator.Damage may result.1. Turn the ice makeroff (allowing any iceto melt off of theevaporator) asfollows:2. Remove all ice fromthe storage bin.3. Remove evaporatorcover (Figure 21).4. Remove the standpipe by lifting it up while using a slight back andforth motion to loosen it from the drain hole. The water in thereservoir will flow down the drain.5. Re-install the standpipe into the water trough.6. Clean the Interior Bin as follows:• Dilute one packet of CLR cleaner into two quarts of water.• Using a sponge or cloth, clean interior of ice bin, tubing anddoor. This cleaner will remove all mineral deposits andother contaminants from the surfaces.• Using a bottle brush, clean out the trough drain tube andpump tubing where needed.7. Place the unit into CLEAN mode by pressing and holding thePOWER button for 10 seconds while pressing the LIGHTbutton three times.8. When water begins flowing over the evaporator (approximately3 minutes), pour 1 packet of CLR cleaner into the water trough.The cleaning process will last approximately 45 minutes.9. Following the cleaning process, sanitize the ice bin with a dilutebleach solution. (1 Tablespoon bleach per gallon of water).Dilute 1 tablespoon bleach in 1 gallon of warm water. Apply thissolution to the entire inside of the storage area. Then rinsethoroughly with water.5 Clear Ice MakerEvaporator coverStandpipeEvaporatorWater troughBrush