Toshiba ST-B10 SERIES Quick Installation Manual

Also see for ST-B10 SERIES: Maintenance manual

Contents

installation procedure

1Quick Installation ManualThis sheet contains only the quick Installation procedures. Please besure to read the Owner’s Manual in the web site for further informationabout this POS terminal.Important Information to the UserIn order to meet Product Safety and EMC legal Requirements, it is advised to socketthe power cord, and interface cable in accordance with the following instructionsOtherwise these devices need to meet following standards.Interface CableYou are advised to use a shielded (360 degrees) interface cable with this product.The shield must be connected to the frame or earth ground connection or earthground reference at BOTH ends of the cable.If another cable is used than described above you will need to test this cable with theTOSHIBA TEC POS terminal and your system for FCC and CE mark certification.Power CordFor this product a UL listed, detachable power cord is required. When the powersupply is mounted on the floor, a power cord with Type SJT marking is required.Outside the US, power cords need to meet the particular country’s certification andapplication requirements. If a power cord is used different from described above youmight violate safety certifications, which are in force in the country of use.CautionThe socket-outlet needs to be installed near the equipment and must be easilyaccessible.Do not connect the LAN cable wired outside of a building to the LAN port provided onthis product directly. The LAN port is intended for indoor connection.If the product is connected to the LAN cable wired outside of a building, be sure touse any communication equipment, such as a router, a hub, or a modem, which islocated within the same building as the product is installed.NoteThe ST-B10 does not support the hot plug / hot unplug features of the Powered USBinterface. In case of plugging or unplugging the Powered USB peripherals attached tothe ST-B10, you are requested to power off the ST-B10.TOSHIBA POS TERMINALST-B10 SERIES