Toshiba SR-M8102 User Manual

Contents

7Figure 2.Inserting Disc VerticallyRemoving a DiscTo remove a disc from the CD-R/CD-RW drive, perform the following steps:1. Open the Loading Tray by pressing the Eject Button.2. Slide disc holders away from disc.3. Grasp disc by edges, and lift out of loading tray.4. Press Eject Button again to close Loading Tray.CD-RW SoftwareAdditional software is required to use the SR-M8102 CD-R/-RW functionsUsage Guidelines• Keep the disc tray closed when not using the CD-R/CD-RW Drive.• Do not press down on the disc tray when opening or closing it.• Do not place objects on the disc tray.• Never use a damaged, broken, or deformed disc.• Do not press the Open/Close button while the drive is accessing a disc.NOTE: High-speed drives spin the disc at a high rotational speed. If a disc has printing on only half of thedisc, or if there is a slight imbalance in the disc, the imbalance is greatly magnified by the high speed,causing the drive to vibrate or produce a fan-like noise. These effects are inherent in the high-speedtechnology and do not indicate a problem with the drive.Emergency EjectionCAUTION: The following procedure is intended only as a last resort when pressing theeject button fails to open the Loading Tray1. Turn computer power OFF by properly shutting down system.2. Insert a solid bar (i.e. large paper clip) into Emergency Eject hole and push in until loading trayopens. Pull tray out.