Toshiba SD-43HK Owner's Manual

Also see for SD-43HK: Owner's manual

0 TroubleshootingCheck the following guide for the possible cause of a problem before contacting service.SymptomNo power.The power is on, butthe DVD receiverdoes not work.Cause• The power cord is disconnected.• No disc is inserted.• Plug the power cord into the wall outletsecurely.• Insert a disc . (Check that the DVD or ,audio CD indicator in the displaywindow is lit.)No picture.No sound.The playbackpicture is poor.The DVD receiverdoes not startplayback.The remote controldoes not workproperly.• The TV is not set to receive DVD signaloutput.• The video cable is not connectedsecurely.• The connected TV power is turned off.• The equipment connected with theaudio cable is not set to receive DVDsignal output• The audio cables are not connectedsecurely.• The power of the equipment connectedwith the audio cable is turned off.• The Digital Audio Output is set to thewrong position.• The disc is dirty.• No disc is inserted.• An unplayable disc is inserted.• The disc is placed upside down.• The disc is not placed within the guide.• The disc is dirty.• The Rating level is set.• The remote control is not pointed at theremote sensor of the DVD receiver.• The remote control is too far from theDVD receiver.• There is an obstacle in the path of theremote control and the DVD receiver.• The batteries in the remote control areexhausted.• Select the appropriate video input modeon the TV so the picture from the DVDreceiver appears on the TV screen.• Connect the video cable into the jackssecurely.• Turn on the TV.• Select the correct input mode of theaudio receiver so you can listen to thesound from the DVD receiver.• Connect the audio cable into the jackssecurely.• Turn on the equipment connected withthe audio cable.• Set the Digital Audio Output to the correctposition, then turn on the DVD receiveragars by pressui9 On/standby(l/U).• Clean the disc.• Insert a disc . (Check that the DVD, or audioCD indicator in the DVD display is lit.)_• Insert a playable disc. (Check the disctype, color system and Regional code.)• Place the disc with the playback sidedown.• Place the disc on the disc tray correctlyinside the guide.• Clean the disc.• Cancel the Rating function or changethe rating level.• Point the remote control at the remotesensor of the DVD receiver.• Operate the remote control within about23 ft (7 m).• Remove the obstacle.• Replace the batteries with new ones.41