Toshiba RBC-AX33UYP-E Installation Manual

Also see for RBC-AX33UYP-E: Operation manual

‒ 1 ‒INSTALLATION MANUALTo Qualified Installer in Installation Work and ServiceWireless receiver kitModel: RBC-AX33UYP-E• Thank you for purchasing Wireless receiver kit for TOSHIBA air conditioners.• Read this manual carefully for correct installation of the Wireless receiver beforestarting work.• After the installation is completed, execute a test run to check for normal operationand explain how to use and maintain the Wireless receiver to the customer accordingto the Owner’s Manual.Ask the customer to keep this manual with the Owner’s Manual.Observe the safety precautions described in the Installation manual supplied with theceiling panel and air conditioner (indoor unit).AccessoriesPart Name Q’tyWireless receiver1Wireless remotecontrolle 1Remote controllerholder 1Part Name Q’tyOperation Manual 1Installation Manual(this manual) 1CD-ROM1Batterry 2Flat head wood screwØ3.1 x 16R 2Settings for the Wireless receiver before installationBefore installing the Wireless receiver, make the following setting referring to eachdescription.• To install the wireless remote controller together with wired remote controller,configure the “Multiple remote controller installation”• When ceiling height exceeds the standard height (factory default), refer to the“Installing indoor unit on high ceiling” on installation manual of the indoor unit.How to install the Wireless receiverInstall the Wireless receiverin correct orientation, sincethe Wireless receiver can beinstalled at only one corneras shown in. (Fig. 1)1. Remove the adjust cornercap at the corner where theWireless receiver is to beinstalled. (Fig. 2)• Pull the edge of the adjust corner capin the direction of arrow.• Remove strap from the pin and detachthe adjust corner cap from the ceiling panel.(Fig. 2)PullAdjust corner capCeiling panelPinStrap2. Wiring the wireless receiver lead wire through to the clamp in the back side of theceiling panel.Wireless receiver wireClamp Clamp3. Attach the Wireless receiver cap to the ceiling panel.• Hook the strap of the Wireless receiver cap securely to the pin.• Insert the two claws A of the Wireless receiver cap into the rectangular holes of theceiling panel in the direction of arrow.• Push the Wireless receiver cap so that the two claws Bon the back of the cap are fitted.PinClaws AClaws B Wireless receiver capStrapPushCAUTIONPress the two claws B of the adjust corner cap firmly as far as they will go, andthen check that the adjust corner cap is closely attached.Failure to do so may result in water leakage.4. Connecting wires of Wireless receiver.• Remove the screw of the electrical control box cover, and detach the electricalcontrol box cover by slide.(The eletrical control box cover is clamped onto the hinge.)• Pass the wireless receiver wire from the ceiling panel through the clamper as shown,and connect the wire to connector CN214 on the P.C. board of the indoor unit.* Connect the wire firmly to the connector to ensure operation of the Wirelessreceiver.• Attach the electrical control box cover by reversing the procedure of detaching.* Make sure that no wire is caught between the electrical control box and thecover.* Make sure that no wire is caught between the indoor unit and the ceilingpanel.Electric controlbox coverCN214 ClamperPass the wirethrough the clamperas illustrated.Wireless receiver wireScrewWire Connection (For illustrative purpose the orientation of the indoor unit is not the actual orientation)(Fig. 1)Wireless receiverinstalling position(English)

/ 2

Related manuals for Toshiba RBC-AX33UYP-E