163Wired remote controller (RBC-AMT32E)Operation manualParts Name of Remote ControllerDisplay sectionIn the display example, all indicators are displayed for the explanation.In reality only, the selected contents are indicated.• When turning on the main power switch and leak breaker at the firsttime, SETTING flashes on the display part of the remote controller.• While this display is flashing, the model is being automaticallyconfirmed.Accordingly, wait for a while after SETTING display has disappeared, andthen use the remote controller.1 SETTING displayDisplayed during setup of the timer etc.2 Operation mode select displayThe selected operation mode is displayed.3 CHECK displayDisplayed while the protective device works or atrouble occurs.4 Timer time displayTime of the timer with H mark is displayed.(When a trouble occurs, the check code isdisplayed.)5 Timer SET IN setup displayWhen pushing the Timer SET IN button, thedisplay of the timer is selected in order of[OFF] → [OFF] repeat OFF timer →[ON] → No display.6 Filter displayIf “FILTER ” is displayed, clean the air filter.7 TEST run displayDisplayed during a test run.8 Louver position display(4-way Air Discharge Cassette,2-way Air Discharge Cassette,1-way Air Discharge Cassette, Under Ceilingand High Wall Type only (2H. 3H))Displays louver position.9 SWING displayDisplayed during up/down movement of the louver.10 Set up temperature displayThe selected set up temp. is displayed.11 Remote controller sensor displayDisplayed while the sensor of the remotecontroller is used.12 PRE-HEAT display (Heat-pump model only)Displayed when the heating operation starts ordefrost operation is carried out.While this indication is displayed, the indoor fanstops or the mode enters in LOW.13 No function displayDisplayed if there is no function even if thebutton is pushed.DisplaysectionOperationsectionSETTIMETIMER SETTESTFILTERLLRESETTECLFANSAVEAASWING/FIXVENTMODEOFFUNIT LOUVER5189 20 1932467 15141811161713 1210This remote controller can controlthe operation of Max. 8 indoor units.