Toshiba RAS-B10 Owner's Manual

Also see for 16J2AVSG-E1: Installation manual

9.7 PLASMA ION OPERATION PURECapture efficiency of floating impurities in the air is accelerated by plasma ioncontaminates such as bacteria, odor, smoke, dust and virus are caught anddeactivated by Plasma Ion.1. Press MENU button for enter menu setting and press TEMP. button toselect PUREMENU°CBlink both triangle andfeature mark Feature notyet set°C2. Confirm selected feature by press MENU button again.MENU°C Blink only triangle Featurealready set°C3. Leave from menu setting display by select EXIT.MENU°CNote:● Plasma Ion operation dose not remove harmful substances from cigarettesmoke (carbon monoxide etc.). Open a window occasionally for ventilation.9.8 POWER-SELECTION OPERATIONTo automatically control room temperature to save energy (except in DRY andFAN ONLY mode)1. Press MENU button for enter menu setting and press TEMP. button to selectPOWER-SELBlink only triangleMENU°C2. Enter POWER-SEL setting by press MENU button again.MENU°C3. Select POWER-SEL level by press TEMP. button.°C100% 75% 50%4. Confirm POWER-SEL level by press MENU button.MENU°C5. Leave from menu setting display by select EXIT.MENU°CMANUAL DEFORST OPERATION10To defrosting the heat exchanger of the outdoor unit during Heating operationPress and hold MENU : for 5 seconds , then remote control display willshow as picture 1 for 2 seconds.1DISPLAY LAMP BRIGHTNESS ADJUSTMENT11To decrease the display lamp brightness or turn it off.1. Press and hold FAN for 3 seconds until brightness level ( , ,or ) is shown on remote control LCD then release the button.2. Press Rise orDecreaseto adjust brightness in 4 levels.Remote controlLCD Operation display BrightnessLamp illuminates full brightness.100%Lamp illuminates 50% brightness.50%Lamp illuminates 50% brightness and theoperation lamp is turned off.50%All lamps are turned off.All turned off● In the examples of and , the lamp illuminates for 5 seconds before going off.AUTO RESTART FUNCTION SETTING12This product is designed so that, after a power failure, it can restart automaticallyin the same operating mode as before the power failure.InformationThe product was shipped with Auto Restart function in the OFF position.Turn it ON as required.How to turn ON the Auto Restart Function● Press and hold the [OPERATION] button on the indoor unit for 3 seconds(3 beep sounds and OPERATION lamp blink 5 time/sec for 5 seconds).How to turn OFF the Auto Restart Function● Press and hold the [OPERATION] button on the indoor unit for 3 seconds(3 beep sounds but OPERATION lamp does not blink).Notes :● In case of ON timer or OFF timer are set, AUTO RESTART OPERATIONdoes not activate.SELF CLEANING OPERATION(COOL AND DRY OPERATION ONLY)13To protect bad smell caused by the humidity in the indoor unit.1. If the button is pressed once during “Cool” or “Dry” mode,the fan will continue to run for other 30 minutes, then it will turn offautomatically. This will reduce the moisture in the indoor unit.2. To stop the unit immediately, press the more 2 times within 30seconds.