Toshiba MV13K1 Service Manual

Also see for MV13K1: Owner's manual Owner's manual

Contents

DISASSEMBLY INSTRUCTIONS2-6: LINK ASS'Y (Refer to Fig. 2-6)Set the Link Ass'y to the Eject position.Remove the (A) side of the Link Ass'y first, then removethe (B) side.1.2.Main Chassis(A)Main ChassisLink Ass'yFig. 2-62-7: LOADING MOTOR ASS'Y (Refer to Fig. 2-7)Remove the Link Lever.Remove the Dumper Spring.Remove the 2 screws 1.Unlock the support 2 and remove the Loading MotorAss'y.Unlock the 2 supports 3 and remove the Deck PCB(BOT).1.2.3.4.5.2-9: TENSION ASS'Y (Refer to Fig. 2-9-A)Move the Inclined S Ass'y to the back side.Unlock the support 1 and remove the S Reel Stopper.Remove the Tension Spring.Unlock the support 2 and remove the Tension ArmAss'y.Remove the Tension Adjust.Unlock the 2 supports 3 and remove the Tension BandAss'y.Unlock the support 4 and remove the Tension Holder.1.2.3.4.5.6.7.Tension Holder42Tension AdjustTension Band Ass'yTension Arm Ass'y1Tension SpringInclined S Ass'yFig. 2-9-ANOTEWhen you install the Tension Adjust, install as shown inFig. 2-9-B. (Refer to Fig. 2-9-B)Adjust the direction of the Marker to inside.Fig. 2-9-B2-10: T BRAKE ASS'Y (Refer to Fig. 2-10)Remove the T Brake Spring.Remove the T Brake Ass'y.1.2.T Brake Ass'yFig. 2-10S Reel Stopper33T Brake Spring121Loading Motor Ass'yLink LeverMain Chassis• Screw Torque: 5 ± 0.5kgf•cm Fig. 2-72-8: SENSOR COVER L (Refer to Fig. 2-8)Unlock the support 1 and remove the Sensor Cover L.Unlock the 2 supports 2 and remove the Deck PCB(EOT).1.2.Deck PCB(BOT)Main ChassisSensor Cover L221Fig. 2-8Deck PCB(EOT)Link Ass'y(B)Dumper Spring3