EN-17COUNTERTOP INSTALLATIONRemove all packing material and accessories. Examine the oven for any damage such as dentsor broken door. Do not install if oven is damaged.INSTALLATION2. Plug microwave oven into a standard household outlet. Be sure the voltage and the frequencyis the same as the voltage and the frequency on the rating label.NOTE• Do not install oven over a range cooktopor other heat-producing appliance.If installed near or over a heat source, theoven could be damaged and the warrantywould be avoid.The accessible surface may behot during operationCabinet: Remove any protective film found on the microwave oven cabinet surface. Do notremove the waveguide cover that is attached to the oven cavity to protect the magnetron.1. Select a level surface that provide enough open space for the intake and/or outlet vents.b. Leave a minimum clearance of 3.0 inches on each side, 3.0 inches on top and 1.0 inch in the rear.c. Do not remove the legs from the bottom of the oven.d. Blocking the intake and/or outlet openings can damage the oven.e.Please place the oven as far away from radios and TV as possible.Operation of microwave oven may cause interference to your radio or TV reception.3.0 inches(7.5cm)3.0 inches(7.5cm)3.0 inches(7.5cm)>36 inches(91.4cm)1.0 inch(2.5cm)a. The minimum installation height is 36 inches.