Toshiba DW-14F1ME(W)-IQ Instruction Manual

1. Remove the lower basket and unscrew the reservoir cap.2. Place the end of the funnel (supplied) into the hole and pour in about 1.5kg ofdishwasher salt.3. Fill the salt container to its maximum limit with water, It is normal for a small amount ofwater to come out of the salt container.4. After filling the container, screw back the cap tightly.5. The salt warning light will stop being after the salt container has been filled with salt.6. Immediately after filling the salt into the salt container, a washing program should bestarted (We suggest to use a short program). Otherwise the filter system, pump or otherimportant parts of the machine may be damaged by salty water. This is out of warranty.Please follow the steps below for adding dishwasher salt:WarningOnly use salt specifically designed for dishwashers use!Every other type of salt not specifically designed for dishwasher use, especiallytable salt, will damage the water softener. In case of damages caused by the use ofunsuitable salt the manufacturer does not give any warranty nor is liable for anydamages caused.Only fill with salt before running a cycle.This will prevent any grains of salt or salty water, which may have been spilled,remaining on the bottom of the machine for any period of time, which may causecorrosion.AttentionThe salt container must only be refilled when the salt warning light ( ) in thecontrol panel comes on. Depending on how well the salt dissolves, the salt warninglight may still be on even though the salt container is filled.If there is no salt warning light in the control panel (for some Models), you canestimate when to fill the salt into the softener by the cycles that the dishwasher hasrun.If salt has spilled, run a soak or quick program to remove it.Adding salt to the softenerEnglish17