Toshiba D-VR3SG Owner's Manual

English - 45System Setup44 - EnglishSystem Setup To adjust the sharpness manually, press the button to turn the IPC mode OFF.6Press the ¥ buttons until the picture is dis-played according to your preferences.• If you do not press a button within ten seconds,the IPC menu disappears automatically.7On completion, press RETURN button to exit themenu.8Select “IPC”Using the buttons, move the selection barto “IPC” then press or OK button to select theIPC option.• When intelligent picture control mode is ON, thesharpness of the image is adjusted automatically.5OffOffOnProgrammeSelect “VCR”Move the selection bar to “VCR”, then press or OK button.4VCRFront Display : Automatic: On: RGBNICAMAV1 OutputProgrammeIntelligent PictureControl (IPC)The intelligent Picture Control Feature allows you toadjust the sharpness of the image automatically, accord-ing to your own preferences.Open “MENU”With the VCR in play mode, Press the MENUbutton.1Select “Setup”Using the buttons, move the selection barto “Setup” then press or OK button to select.2Select “System”Using the buttons, move the selection barto “System” then press or OK button to select.3Programme You also can directly select this function usingIPC button on the remote control.NoteSelect “Colour System”Using the buttons, move the selection barto “Colour System” then press or OK button toselect Colour System option.Automatic -> PAL -> B/W.• Automatic : When playing back a tape, the sys-tem standard is automaticallyselected by the DVD Recorder-VCR.• B/W : Black and White.5Select “VCR”Move the selection bar to “VCR”, then press or OK button.4VCRFront Display : Automatic: On: RGBNICAMAV1 OutputProgrammeSelection the ColourModeBefore recording or playing back a tape, you can selectthe required system standard. Otherwise, the systemautomatically selects the reception standard when youselect Automatic.• When playing back a tape, the standard is automatical-ly selected by the DVD Recorder-VCR.Open “MENU”With the VCR in play mode, Press the MENUbutton.1Select “Setup”Using the buttons, move the selection barto “Setup” then press or OK button to select.2Select “System”Using the buttons, move the selection barto “System” then press or OK button to select.3On completion, press RETURN three times toexit the menu.6ProgrammeProgramme