Toshiba D-R160SB Owner's Manual

Contents

Introduction14 ENIndex to parts and controlsREC MODE RECPROGRAM I /yON / STANDBY8*91211 101314151 2 3* 4 5 6 7S-VIDEO VIDEO LAV4 R1. Disc trayPlace a disc here when open.2. DisplayRefer to “Front Panel Display Guide” on page 18.3. A (OPEN/CLOSE) button*Press to open or close the disc tray.4. PROGRAM / buttonPress to change the channel up or down.5. H (REV) buttonDuring playback, press once midway through achapter or track to go back to the beginning of thecurrent chapter or track. When pressed twice inquick succession, playback will start from thepreceding chapter or track.During playback, press and hold for 1.5 seconds tofast reverse.When playback is paused, press to play reversestep by step.When playback is paused, press and hold for 1.5seconds to slow reverse.6. G (FWD) buttonDuring playback, press to skip to the next chapter ortrack.During playback, press and hold for 1.5 seconds tofast forward.When playback is paused, press to play advancestep by step.When playback is paused, press and hold for 1.5seconds to slow forward.7. C (STOP) buttonPress to stop play or recording.Press to stop a timer recording.8. B (PLAY) button*Press to start or resume playback.9. I/y (ON/STANDBY) buttonPress to turn on or off the unit.If timer programming is set, press to switch the unitto timer-standby mode.10. AUDIO input jacks (AV4)Use to connect external equipment with a standardAudio cable.11. VIDEO input jack (AV4)Use to connect external equipment with a standardVideo cable.12. S-VIDEO input jack (AV4)Use to connect the S-Video output of externalequipment with an S-Video cable.13. I REC buttonPress once to start a recording.Press repeatedly to start a One-touch TimerRecording.14. REC MODE buttonPress to switch the recording mode.15. Remote control sensorReceives signals from your remote control so youcan control the unit from a distance.* You can also turn on the unit by pressing thesebuttons.Front PanelButton names described in the Owner’s ManualThe instructions in this manual are described mainly with the operations using the remote control. Some operations canbe carried out using the buttons on the front panel.