Toshiba D-R150SB Owner's Manual

Also see for D-R150SB: Quick reference guide Owner's manual

15Connections Basic SetupIntroductionTo wall outletNotes• Refer to the owner’s manual of the connected TV as well.• When you connect the recorder to your TV, be sure to turn off the power and unplug both units from the wall outlet before anyconnections.• Connect the recorder directly to your TV. If you connect the recorder via a VTR, TV/VTR combination or video selector, theplayback picture may be distorted due to copy protection.3 Connect to a TV equipped with SCART inputs.Connect as below for watching received channels or recorded contents. Watching via the RF OUT terminalis not available.4 Connect the power cord of the recorder to a wall outlet.SCART cable (not supplied)To AV1(TV)To SCART input• Normal TV• TV compatible with S video signals• RGB monitorPlug & Auto Set Up functionThis recorder will automatically set itself up when it is pluggedinto the mains for the first time.TV stations will be stored in the recorder’s memory. The processwill finish after a few minutes. Then the date and time are setautomatically from broadcast signal.Notes• The display on the recorder shows “Auto” while the Plug & Auto SetUp function is running.• TV stations are stored in the range of UHF E21-E69.• You can only use the ON/STANDBY button and OPEN/CLOSE buttonwhile the Plug & Auto Set Up function is running.• The automatic setup is cancelled, if you press the ON/STANDBYbutton while the Plug & Auto Set Up function is running.• The Plug & Auto Set Up function may not work, depending on theradio reception or other conditions. In this case, refer to “Initialsettings” in this Owner’s Manual for the setup.To use the phono type jacks to connect the TV ( page 16), to usethe component video jacks to connect the TV ( page 17), or toconnect the satellite receiver ( pages 18, 19) complete thenecessary connection before connecting the power cord.• The following setting is required according to the TV thatyou are connecting. Perform this setting after step 4.For connections to TVs with no SCARTinputs, see “Connecting to a TV equippedwith phono type jacks” ( page 16).Setting “AV1 output” on the“Initial settings” menu.page 38Normal TV “Video”TV compatible withS video signals “S-Video”RGB monitor “RGB”“Audio out select” on the“Picture/Audio settings”menu. page 40TV“Analog 2ch”“Analog 2ch”“Analog 2ch”03_D-R150SB(E)_inst_13-20 05.7.13, 0:23 AM15Downloaded From Disc-Player.com Toshiba Manuals