Toshiba D-KVR20KU Owner's Manual

Also see for D-KVR20KU: Owner's manual

Contents

104 EN104 ENTROUBLESHOOTINGSymptom RemedyDVDThe subtitle language cannot bechanged or turned off.• Multilingual subtitle are not recorded on the DVD-video.The angles cannot be changed. • Multi-angles are not recorded on the DVD-video being played back.• The angle-change operation is whenever possible as long as the disccontains a multi-angle portion. Actual change will be performed whenthe portion has come up.• The DVD-video prohibits changing angles.• Try changing the angle using the DVD-video’s menu.Recording does not stop immediatelyafter you press [STOP C].• It may take a few seconds for the unit to input disc data beforerecording stops.The disc tray does not open when youpress [OPEN/CLOSE A].• It may take a few seconds for the disc tray to open after you haverecorded or edited a disc. This is because the unit is adding disc data tothe disc.“Repairing” appears on the TV screen.Repairing• If there is a power failure or unplugging during recording, finalizing,formatting or editing (even after “Repairing” disappears), a repairingprocess will begin automatically just after turning the unit on again.It may take several minutes up to about several hours.In a case you intend to cancel therepairing process.RepairingDo you want to cancel a repairingprocess ? When selecting “Yes”,the disc may not be usable.YesNo• If you intend to cancel the repairing process, press [A OPEN/CLOSE]on the front panel, then select “Yes” and press [ENTER]. After that, press[OPEN/CLOSE A] to take out the disc. The disc canceled during therepairing process MAY NOT work.No image from HDMI connection. • Check the HDMI connection. (Check the status of the HDMI relatedindications.)• Check whether the connected monitor device or other device supportsHDCP. (This unit will not output a video signal unless the other devicesupports HDCP.)• Check the setting of HDMI.• Check whether the output format of this unit (HDMI FORMAT) matchesthe supported input format of other connected device.• If the unit is connected to the unauthorized display device with anHDMI cable, the audio/video signal may not be output when playingback a commercial DVD-video.There is no sound or the sound isdistorted.• The HDMI sound is not output when “HDMI Audio” is set to “OFF”.• Check the RCA audio cable connection. If you are using HDMI-DVIconversion cable, you must connect the RCA audio cable, too.• Check whether the output format of this unit (HDMI FORMAT) matchesthe supported input format of other connected device.VCRThere is no picture. • If you connect the cable to S-VIDEO OUT/ COMPONENT VIDEO OUT /HDMI OUT jack, try connecting it to AUDIO / VIDEO OUT jack instead.Picture noise appears. • Head cleaning for VCR may be necessary. Refer to “Auto Head Cleaning”(page 5).• Adjust tracking control for better picture by pressing [TRACKING / ]while you are playing back a cassette tape.The cassette tape does not play back. • No cassette tape is inserted.The tape ejected after you press[REC I].• Make sure the cassette tape has an erase-protection tab when yourecord to a cassette tape. If needed, cover the hole with cellophanetape.The remote control does not function. • Check if a cassette tape is in this unit.The motor rotates even whenplayback / recording is stopped.• The motor may rotate for the duration of approximately 5 minutes forefficient operation. This is not a malfunction.E9KGBUD_D-KVR20KU_EN.indd 104E9KGBUD_D-KVR20KU_EN.indd 104 2008/05/27 16:11:522008/05/27 16:11:52Downloaded From Disc-Player.com Toshiba Manuals