Toshiba B-EX700-RFID-H3-QM-R Installation Manual

1/15B-EX700-RFID-H3-QM-R Installation ManualThank you for purchasing TOSHIBA TEC HF RFID kit, B-EX700-RFID-H3-QM-R.The B-EX700-RFID-H3-QM-R is exclusively for the B-EX4T1-GS12/TS12-QM-R.This unit must come together with B-EX904-R-QM-R Ribbon Saving Module during installation.This RFID kit complies with radio laws of all applicable countries.As this product is a wireless communication device, please be sure to read the followingprecautions carefully.WARNING!1. Do not use a printer embedded with this product near medical equipment. Radio wave emittedfrom this product may affect the operation of medical equipment, such as an implantedcardiac pacemaker and implantable cardioverter-defibrillator.If a use of this product should be likely to have affected medical equipment, immediatelyturn off the product and contact your TOSHIBA TEC sales agent.Keep a printer embedded with this product at least 23cm away from a person with an implantedcardiac pacemaker or implantable cardioverter-defibrillator.2. Do not export a printer embedded with this product to the countries or areas where a use of thisproduct is not allowed, without permission. Doing so is against the law, and you may bepunished.When exporting this product, check the laws and regulations of a destination country and takenecessary procedures.3. Follow all manual instructions. Failure to do so could create safety hazards such as fire orelectrocution. Manual instructions must be followed when installing option kits or adding cables to avoidsystem failures and to insure proper performance and operation. Failure to follow manual instructions or any unauthorized modifications, substitution orchange to this product will void the limited product warranty.4. Turn the power OFF and disconnect the power cord before installing the RFID module.5. Be careful not to pinch your fingers or hands with the covers.6. The print head and stepping motor becomes very hot immediately after printing. Do not touchthe print head, stepping motor and around it right after printing, or you may get burned.7. When opening the top cover, it must be fully opened. Failure to do this may cause the top coverto close under its own weight, resulting in an injury.2/151. APPLICABLE MODEL(1) This optional device is intended for the followingmodels: B-EX4T1-GS/TS12-QM-RBe careful not to install this product in any other models than above.(2) The countries where the use of this device is allowed are as follows:Module Name Frequency Band Applicable CountriesTRW-HFM-01 HF 13.56 MHz Korea2. PACKING LISTAll the following parts are supplied with the kit. Make sure you have all items shown below.If any part is missing, please contact your TOSHIBA TEC sales agent. Antenna Unit (1 pc.)  RFID R/W Module (1 pc.)  Ribbon Guide (1 pc.) Interface Cable (1 pc.)  Cord Bush (1 pc.)  Antenna Cable (1 pc.) Double-Sems ScrewSMW-3x6 (1 pc.) Tapping ScrewPT-3x6 (5 pcs.) R/W Module Attachment Plate(2 pcs.) Earth Plate (1 pc.)  Installation Manual (1 copy)