Toshiba B-852 Series Supply Loading Instructions

Also see for B-852 Series: Owner's manual

1TOSHIBA Thermal PrinterB-852 SeriesSUPPLY LOADING INSTRUCTIONSThis sheet contains only the media and ribbon loading procedures. Please be sure to read the Owner’s Manual inthe CD-ROM for further information about this printer.1. LOADING THE MEDIA1.1 Assembling the Supply Holder Frame1. Assemble the Supply Holder Frame (L) and Supply Holder Frame (R) to the Supply Holder Base using thetwo M-4X6 Wing Bolts supplied, as shown below.1. Do not touch any moving parts. To reduce the risk of fingers, jewellery, clothing, etc., being drawn into themoving parts, be sure to load the media once the printer has stopped moving completely.2. The Print Head becomes hot immediately after printing. Allow it to cool before loading the media.3. Care must be taken not to pinch your fingers when opening or closing the Top Cover.4. Be careful not to pinch your fingers by the Supply Holder Frame or Media Holders when loading the media.AVERTISSEMENT!1. Ne touchez pas aux éléments en mouvement. Pour éviter les risques que les doigts, les bijoux leshabits, etc. soient tirés vers les éléments en mouvement, rassurez-vous de charger le média lorsquel'imprimante est arrêtée complètement.2. La tête chauffe beaucoup en imprimant. Laissez-la refroidir avant de charger le média.3 .Prenez garde à ne pas vous pincer les doigts lorsque vous manipulez la capot supérieur ou le capotcoté droit.4. Prenez garde à ne pas vous pincer les doigts lorsque vous manipulez le cadre support média ou lesguides lors du chargement média.WARNING!Supply Holder BaseSupply Holder Frame (L)Supply Holder Frame (R)Wing BoltNOTE:Make sure that the two small flanges at each end of the Supply Holder Base fit into the small rectangular holes at thebottom of the Supply Holder Frames before tightening the Wing Bolts.! 0 0 T S C C 0 1 5 6 6 0 3 !