97Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.Chapter 8: Using the TV’s featuresDisplaying the Channel BannerTo display the channel banner:Press RECALL on the remote control.The following information will display in the channel banner(if applicable):• Current input (ANT 1, ANT 2, VIDEO 1, etc.)• If ANT 1 or ANT 2 is the current input, whether it isCable TV (“CABLE”) oroff-air (“TV”)• Channel number (if inANT 1 or ANT 2 mode)• Signal strength indicator(bar graph in lower rightcorner of banner; forATSC signal only)Note: The signal strength indicator will react to fading andincreasing signals and could display longer than the normalchannel banner screen.• Time (if set)• On/Off timer settings (if set)• Remaining time on sleep timer (if set)• Remaining time on game timer (if set)• Stereo or SAP audio status• V-Chip rating status• Picture size• Tuner hold* (if applicable)*If you are recording on one tuner (for example, the digitaltuner), you will be able to change channels on the other tuneronly (the analog tuner in this example). The tuner from whichyou are recording is “on hold” (i.e., locked) so yourrecordings will not be affected by channel changes.• Aspect ratioTo close the channel banner:Press RECALL again.Understanding the auto power offfeatureThe TV will automatically turn itself off after approximately 15minutes if it is tuned to a vacant channel or a station thatcompletes its broadcast for the day. This feature functions inANT 1 and ANT 2 modes only.Understanding the last modememory featureIf the power is cut off while you are viewing the TV, the LastMode Memory feature automatically turns on the TV whenthe power is resupplied.Note: You should unplug the TV’s power cord if it is possiblethat you will be away from the TV for an extended period of timeafter the power is restored.STEREO Tuner Hold: On5:32pm CABLE 81-1ANT 1NC-17On Timer: Weekdays 12:00pmSleep Timer: 18 min.Game Timer: 28 min.Natural1080iSample channel banner screen
