Toshiba 43A62 Service Manual

Also see for 43A62: Owner's manual Owner's manual

– 20 –GENERAL ADJUSTMENTSSPECIFIC INFORMATIONSPROGRAMMING CHANNEL MEMORYThe channel memory is the list of TV channel numbers the TV tunes in when you press the CHANNEL s or t button.First, use the TV/CABLE and CH PROGRAM functions to preset all active channels in your area automatically.If necessary, arrange the preset channels with the ADD/ERASE functions so that you can tune into only desired channels.Note: If you utilize both ANT-1 and ANT-2 terminals for some model, perform programming channels for each input source.TV/CABLE function1 Press MENU, then press S or T until the SET UP menuappears.2 Press t (or s) until “TV/CABLE” is highlighted.3 Press : or ; to highlight either “TV” or “CABLE”, whicheveryou use.CH PROGRAM function1 Select “CH PROGRAM” following steps 1 and 2 above.2 Press : or ; to start channel programming.The TV will automatically cycle through all the TV orCABLE channels selected by the TV/CABLE function, andstore active channels in the channel memory.3 When channel programming is complete, you will see themessage to the right appears.4 Press CHANNEL s or t to make sure the channelprogramming has been done properly.ADD/ERASE functionAfter performing the CH PROGRAM function, you can add orerase specific channels.1 Select the channel you want to erase using the CHANNELs or t button, or select the channel you want to add usingthe Channel Number buttons.2 Press MENU, then press S or T until the SET UP menuappears.3 Press t (or s) until “ADD/ERASE” is highlighted.4 Press S or T :To erase the channel press the button until “ERASE” ishighlighted.To add the channel press the button until “ADD” ishighlighted.5 Repeat steps 1 to 4 for other channels.You have now completed the channel programming.Note: The CHANNEL t/s buttons on the TV function as thet/s buttons while a menu is on the screen.* Please refer to owner's manual in detail.