Toshiba 43A10 Service Manual

Also see for 43A10: Owner's manual Service manual Owner's manual

SCHEMATIC DIAGRAMWARNING: BEFORE SERVICING THIS CHASSIS, READ THE "X-RAY RADIATION PRECAUTION", "SAFETYPRECAUTION" AND "PRODUCT SAFETY NOTICE" ON THE MANUAL FOR THIS MODEL.CAUTION: The international hazard symbols "*" in the schematic diagram and the parts list designate componentswhich have special characteristics important for safety and should be replaced only with types identical to those in theoriginal circuit or specified in the parts list. The mounting position of replacements is to be identical with originals.Before replacing any of these components, read carefully the PRODUCT SAFETY NOTICE on the MANUAL for thismodel. Do not degrade the safety of the receiver through improper servicing.NOTE:1. RESISTOR Resistance is shown in ohm [K = 1.000, M = 1.000.000]. All resistors are 1/6W and 5%tolerance carbon resistor, unless otherwise noted as the following marks.1/2R = Metal or Metal oxide of 1/2 watt 1/2S = Carbon compsistion of 1/2 watt1RF = Fuse resistor of 1 watt 10W = Cement of 10 wattK = ±10% G = ±2% F = ±1%2. CAPACITOR Unless otherwise noted in schematic, all capacitor values less than 1 are expressed in?F, and the values more than 1 in pF.All capacitors are ceramic 50V, unless otherwise noted as the following marks.Electolytic capacitor Mylar capacitor3. The parts indicated with " * " have special characteristics, and should be replaced with identical parts only.4. Voltages read with DIGITAL MULTI-METER from point indicated to chassing ground, using a color bar signal with allcontrols at normal, line voltage 120 volts.5. Waveforms are taken receiving color bar signal with enough sensitivity.6. Voltage reading shown are nominal values and may vary ±20% except H.V.MODEL : 50A60 Chassis No. TAC005050A50 Chassis No. TAC005155A60 Chassis No. TAC005261A60 Chassis No. TAC0053