Toshiba 27WL55A Schematic Diagrams

Also see for 27WL55A: Owner's manual Schematic diagram

NOTE:1. RESISTOR Resistance is shown in ohm [K = 1.000, M = 1.000.000]. All resistors are 1/6W and 5%tolerance carbon resistor, unless otherwise noted as the following marks.1/2R = Metal or Metal oxide of 1/2 watt 1/2S = Carbon compsistion of 1/2 watt1RF = Fuse resistor of 1 watt 10W = Cement of 10 wattK = ±10% G = ±2% F = ±1%2. CAPACITOR Unless otherwise noted in schematic, all capacitor values less than 1 are expressed in?F, and the values more than 1 in pF.All capacitors are ceramic 50V, unless otherwise noted as the following marks.Electolytic capacitor Mylar capacitor3. The parts indicated with " * " have special characteristics, and should be replaced with identical parts only.4. Voltages read with DIGITAL MULTI-METER from point indicated to chassing ground, using a color bar signal with allcontrols at normal, line voltage 220 volts.5. Waveforms are taken receiving color bar signal with enough sensitivity.6. Voltage reading shown are nominal values and may vary ±20% except H.V.MODEL : 27WL55A / 27WL55E / 27WL55R / 27WL55TSCHEMATIC DIAGRAMWARNING : BEFORE SERVICING THIS CHASSIS, READ THE "SERVICE SAFETY PRECAUTIONS" ON PAGE 3 OFTHIS MANUAL.CAUTION : The international hazard symbols " " in the schematic diagram and the parts list designate componentswhich have special characteristics important for safety and should be replaced only with types identical to those in theoriginal circuit or specified in the parts list. The mounting position of replacements is to be identical with originals. Beforereplacing any of these components, read carefully the SERVICE SAFETY PRECAUTIONS on the MANUAL for thismodel. Do not degrade the safety of the receiver through improper servicing.