Toshiba 24WA2063DAX Quick Start Manual

Also see for 24 WA20 Series: Quick start guide Operating instructions

English - 1 -1 Inserting the batteries into the remoteRemove the screw that secure the battery compartment cover on the back side of the remote control first. Liftthe cover gently. Insert two 1.5V - size AAA batteries. Make sure the (+) and (-) signs match (observe correctpolarity). Do not mix old and new batteries. Replace only with same or equivalent type. Place the cover backon. Then screw the cover back on again.2 ConnectionsAntennaConnect the antenna cable/s to your TV.satellitedishaerial /cable TVrear side of the TVExternal DevicesPLEASE ENSURE BOTH UNITS ARESWITCHED OFF BEFORE CONNECTINGUse the proper cable to connect two units together.To select the desired input source, press the Sourcebutton on the remote control.HDMI connectionrear side or rear-leftside of TVPowerAfter unpacking, allow the TV set to reach the ambient room temperature before youconnect the set to the mains. Plug the power cable to the mains socket outlet.IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.Switching on the TV3In order to turn the TV on from standby mode:• Press the Standby button on the remote control• Press the centre of the control switch inwards, located at the rear left hand sideof the TV-or-In order to turn the TV on from standby mode:• Press the Standby button on the remote control• Press the control button on the TV