Toshiba 2.5-Zoll SATA 6Gbit/s SSD Manual

Please be sure to check www.ocz.com for the latest firmware updates.Note: The following instructions are a general guideline for the SSD installation and should act as a complementto your system’s owner manual.SSD HANDLING PRECAUTIONS· To minimize static electricity, touch a metal surface before handling the SSD.· Keep the drive away from direct sunlight, moisture, and extreme temperatures.LAPTOP INSTALLATION1. Power off the system, disconnect all power cables, and remove the battery.2. Locate the hard drive access panel; unscrew and remove the access panel.3. Disconnect and remove the current storage drive from the drive bay(refer to your system’s user manual)4. Remove all brackets and connectors from your HDD and install it on the SSD (if necessary).Note: If a proprietary connector and/or bracket are present on the HDD, carefully remove it and connect itto the SSD. Systems will vary and these items may or may not be present.5. Insert the SSD into the drive bay carefully aligning the SSD with the SATA* connectors.6. Secure the SSD in the drive bay. Reinstall the access panel and insert the battery back into the system.7. Power on your system to verify a successful installation. For a boot drive, this is signified by the BIOSprompting OS installation. For a secondary drive, follow the format instructions below.Note: If the SSD will be your primary boot drive, please refer to your operating system’s usermanual for further OS installation instructions. If this SSD will be used as a secondary drive, formatting thedrive is required before use.*SATA 6Gbit/s is backwards compatible with SATA 3Gbit/s. However, connecting a SATA 6Gbit/sdevice into a SATA 3Gbit/s connection will result in reduced performance.2.5-inch SATA 6Gbit/s SSD ManualISF-SSD2-SATA3-ML-V4