Toshiba 13A26 Owner's Manual

Also see for 13A26: Owner's manual Owner's manual Service manual Service manual

Contents

6MENUVOL–SLEEP MUTECH RTN RECALLVOL+ENTERCH –CH +1 2 34 5 6708 9– SET +1/2CAP/TEXTRESETTV/VIDEOCT-859POWER4. SLEEP Button - To set the TV to turn off after a presetamount of time, press the SLEEP button on the remotecontrol. The clock will count down 10 minutes each timethe button is pressed in the order of 120, 110, 100, ······ 20,10, 0. After the sleep time is programmed, the display willdisappear then reappear momentarily every ten minutes toremind you the sleep timer function is operating. Toconfirm the sleep time setting, press the SLEEP buttononce and the remaining time will be momentarily displayed.To cancel sleep time, press the SLEEP button repeatedlyuntil the display turns to 0.5. VOL (VOLUME) + / – Buttons - Press the + button toincrease or the – button to decrease the volume level.6. MENU Button - Press to display the on-screen menufunction.7. SET + / – Buttons - Press to select the desired settingduring on-screen operations.8. RESET Button - Press to reset the on-screen pictureadjustments to their factory preset positions.9. TV/VIDEO Button - Switches between the TV and externaldevice inputs.10. RECALL Button - When you press this button, thechannel number will appear in the upper right corner of thescreen. Press the button again to remove it from thescreen.11. MUTE Button - To turn off the sound, press this buttononce. The TV will be silenced and the word “MUTE” willappear on the screen. The muting feature can be releasedby pressing the MUTE button again or one of the VOL + or– buttons.12. CH (CHANNEL) + / – Buttons - Press the + button tochange to a higher numbered channel set into memory.Press the – button to change to a lower numbered channelset into memory.13. ENTER Button - Press to enter or select information forOn-screen operations.14. 1/2 Button - Switches between channel 1 and channel 2in the closed caption mode.15 . CAP/TEXT Button - Press to switch between normal TVand the two closed caption modes (captions or text), whenavailable.REMOTE CONTROL1. Open the battery compartment cover.2. Install two “ AAA” (penlight size) batteries.HOW TO INSTALL BATTERIESBefore using the remote control, batteries must first be installed.3. Replace the battery compartment cover.1. POWER Button - Press to turn on the TV. Press againto turn off the TV.2. Direct Channel Selection Buttons (0–9) - Allows directtuning of any channel.3. CH RTN Button - Repeatedly press CH RTN to toggleback and forth between the last two channels you tuned.123567891011121314415Use two “ AAA” size penlight batteries (supplied) for theremote control. The batteries may last approximately oneyear depending on how much the remote control is used.For best performance, it is recommended that batteriesshould be replaced on a yearly basis, or when the remoteoperation becomes erratic.Caution:Never throw batteries into a fire.Notes :• Be sure to use AAA size batteries.• Dispose of batteries in a designated disposal area.• Batteries should always be disposed of with theenvironment in mind. Always dispose of batteries inaccordance with applicable laws and regulations.• If the remote control does not operate correctly, or if theoperating range becomes reduced, replace batteries withnew ones.• When necessary to replace batteries in the remote control,always replace both batteries with new ones. Never mixbattery types or use new and used batteries in combination.• Always remove batteries from remote control if they aredead or if the remote control is not to be used for anextended period of time. This will prevent battery acidfrom leaking into the battery compartment.3X00121A(E)_P02-07 12/26/05, 1:49 PM6