OneStart

Menu
Toro VR-2650 Operator's Manual Manual pdf 11 page image

Toro VR-2650 Operator's Manual

Also see for 68034: Operator's manual

Page 1 previewPage 2 previewPage 3 previewPage 4 previewPage 5 previewPage 6 previewPage 7 previewPage 8 previewPage 9 previewPage 10 previewPage 11 previewPage 12 previewPage 13 previewPage 14 previewPage 15 previewPage 16 previewPage 17 previewPage 18 previewPage 19 previewPage 20 previewPage 21 previewPage 22 previewPage 23 previewPage 24 preview
Contents
  1. Figure
  2. Table Of Contents
  3. Safety and Instructional Decals
  4. Product Overview
  5. Specifications
  6. Checking the Engine-oil Level
  7. Checking the Spring-housing Oil
  8. Transporting the Machine
  9. Maintenance
  10. Disconnecting the Spark-plug Wire
  11. Servicing the Engine Oil
  12. Servicing the Spring-housing Oil
  13. Servicing the Spark Plug
  14. Compactor Shoe Maintenance
  15. Storage
  16. Troubleshooting
Toro VR-2650 Operator's Manual Manual pdf 11 page image
Checking the Spring-housingOilService Interval: Before each use or dailyOil Type: 4-cycle engine oil that meets or exceeds therequirements for API service category SJ, SL, SM, or higher.Capacity: 0.47 L (0.5 US qt)Viscosity: SAE 10W-30 is recommended for general use.Check the spring-housing oil as follows:1. Carefully tip the machine slightly backward, so that itstands completely upright and vertical.Important: Prop or lean the machine againstsomething to ensure that it does not fall over.2. Check the oil sight plug (Figure 11), and ensure thatthe oil level is halfway between the top and bottomof the oil sight plug.1G023141Figure 111. Oil sight plug3. If the oil level is low, add oil; refer to Adding Oil to theSpring Housing (page 17).Starting and Stopping theEngineStarting the Engine1. Move the engine on/off switch to the run position(counterclockwise); refer to Engine On/Off Switch(page 6).2. Move the choke lever to the closed position if you arestarting a cold engine; refer to Choke Lever (page 7).Note: A warm or hot engine may not require choking.3. Move the throttle lever to the slow position; refer toThrottle Lever (page 7).4. Pull the recoil-starter handle lightly until you feelresistance, then pull the handle briskly. Gently returnthe handle to the original position.5. After the engine starts, gradually move the chokelever back to the open position. If the engine stallsor hesitates, move the choke lever back to the closedposition again until the engine warms up. Then moveit to the open position.Stopping the Engine1. Move the throttle lever to the slow position. If theengine has been working hard or is hot, let it run for aminute. This helps to cool the engine before stopping.Important: To stop the engine immediately, youcan move the engine on/off switch to thestopposition before moving the throttle lever to theslow position.2. Move the engine on/off switch to the stop position(clockwise).11
/ 24
Related manuals for Toro 68034
Toro 04474 Installation Instructions Manual first page preview
Toro 04474 Installation Instructions Manual
This manual is suitable for:
680346803568036VR-2650VR-3100VR-3500
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved