Menu
Toro LT3240 Instruction Manual & Parts List
                                                                |
Issued: 01.04.11 Approved: Mod. No. 5060358 Sheet 41 of 64 Part No. 111-4431 (A)SAFETY CAB GENERAL ASSEMBLY - WIRING29. Connect the red positive washer bottle wire to the red fusebox positive battery feed. Refer to Fig 43.Connect the red/black wire from the cab to the other side ofthe fuse box.Connect the brown negative wire tot he frame.Connect the short red/black ignition wire assemblyconnected to the other side of the fuse in the fuse box toterminal 58 on the ignition switch.Cable tie the cab wiring connections and the fuse box tosecure them safely in place.30. Lower the cab/platform assembly.31. Remove the two rearmost M8*30 setscrews (item 43) whichsecure the fuel tank retaining brackets. Fit the LH and RHcab support bracket assemblies with mounting plates (item58) beneath the chassis mounting points using 4 M12*40bolts, nuts and washers. Do not fully tighten at this stage.Refer to Fig 44.32. Lift the loosely bolted cab support 'U' bracket into positionand insert the retaining pins. Measure the free verticalclearance in order to make an assessment of the number ofspacer plates and or thrust washers required for the finalassembly.33. Replace the four M12*30 setscrews (removed at stage 33)to secure the fuel tank retaining brackets and tightensecurely. Fully tighten all fasteners which secure the LH andRH cab support bracket assemblies.34. Seek assistance and replace the roof panel.35. Replace the cab doors and fasten securely.36. Fill the washer bottle.37. Reconnect the battery terminals.38. Replace the tool tray to protect the battery.Fig 43Fig 44 |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved